Tegra: USB: EHCI: add Tegra30 compatible support
Get series with b4
b4 am [email protected]Versions newest first
- v1 Latest0 of 3 patches 0 repliesNew
Patches in v1 No applies recorded yet
None of the 3 patches the cover letter announces are in this archive.
Reviews trailers per patch
No Reviewed-by, Acked-by or Tested-by trailers for v1 yet.
Cover letter [U-Boot] [PATCH 0/3] Tegra: USB: EHCI: add Tegra30 compatible support
Quoted 11 lines · Stephen Warren
Quoted 9 lines · Jim Lin
Tegra114 USB EHCI is compatible with Tegra30 USB EHCI except:
1. Port Reset - Tegra30 takes 55ms, Tegra114 takes 50 ms to finish.
2. PLL parameters.Jim Lin (3):
ARM: Tegra: FDT: Add USB support for T20/T30/T114
ARM: Tegra: USB: Add driver support for Tegra30/Tegra114
Tegra: Config: Enable Tegra30/Tegra114 USB function
Quoted 6 lines
The series,
Tested-by Stephen Warren <[email protected]>On both Cardhu (Tegra30) and Dalmore (Tegra114). :-) :-) Now, I can netboot with upstream U-Boot on all my boards.
I just noticed one problem with this patch series. If I run the following commands with Cardhu in its dock, and a USB Ethernet dongle attached to the dock:
usb start 0
dhcp ${scriptaddr} boot.scr.uimg
... then everything works as expected; the file is downloaded.
However, if I run those same commands with Cardhu either undocked, or docked but with no USB Ethernet dongle plugged into the dock, then the dhcp command hangs the system hard; CTRL-C won't interrupt it for example.
Can you please fix this?