Skip to contentSkip to conversation

IGB driver load resets NC-SI interface on Rangeley C2000

Intel-wired-lan Owen Wells 1 participant 1 message Dec 2, 2015

lore
Share & tools
lore

Owen Wells

author
#0 lore raw

Hi,

I was referred to this email address by Juan Nu?ez Quesada, the application support engineer assigned to our IPS case.

We have a BMC connected to Rangeley (Atom C2000) via the NC-SI interface. We are able to get to the LAN to/from the BMC, so that works. The issue is that while Linux is booting, the IGB driver loads and resets the NC-SI interface, causing us to lose connection with the BMC. We can reconnect after the reset, but that is not acceptable to the customer
. They need a solid
connection.

We would like to understand how and why the IGB driver is resetting the NC-SI interface. That technically should not happen
the NC-SI interface
should be up at all times so that the BMC can stay on the network even when Rangeley is shut down.

As an experiment, I did try modifying some EEPROM settings to prevent the IGB driver from resetting the interface. Specifically, I cleared bit 0 of the Initialization Control 4 word in the EEPROM (LAN base address + Offset 0x13) to disable software reset. This does not appear to have an effect.

Please assist. Thanks!

Owen Wells

Senior Staff Hardware Engineer

ADI Engineering, A Division of Silicom

Cell +1-434-760-0289

Skype owen.wells

owen.wells at adiengineering.com

www.adiengineering.com <http://www.adiengineering.com/>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.osuosl.org/pipermail/intel-wired-lan/attachments/20151202/be107484/attachment-0001.html>