Skip to contentSkip to conversation

pcmcia hdsp problems

DISCUSSION jfm3 2 participants 2 messages May 8, 2003

lore
Share & tools
lore

jfm3

author
#0 lore raw

I'm running the latest Planet CCRMA on Redhat 8. This is alsa 9.2 and kernel 2.4.20 with the usual audio patches. I've taken the plunge and acquired a hdsp Multiface. I'm using it with a PCMCIA interface.

I put 'modprobe snd-hammerfall-mem enable=1' as the first thing that happens in /etc/rc.sysinit. It doesn't seem to allocate any memory. When the machine first boots with the PCMCIA card in, it lists it as this:

$ lspci
...
01:00.0 Class ffff: Illegal Vendor ID: Unknown device ffff (rev ff)

If I remove the card with cardctl eject and put it back in, it shows up.

$ lspci
...
01:00.0 Multimedia audio controller: Xilinx, Inc. RME Hammerfall DSP
(rev 0b)

At this point I can reload snd-hammerfall-mem and snd-hdsp and they don't complain. The bright red HOST light is still on though. Of course, at this point, it is probably too late for snd-hammerfall-mem to have been loaded correctly.

Does the enable argument to snd-hammerfall-mem do anything anymore? Any other ideas?

Signature · 8 lines
(jfm3  2838 BCBA 93BA 3058 ED95  A42C 37DB 66D1 B43C 9FD0)



-------------------------------------------------------
Enterprise Linux Forum Conference & Expo, June 4-6, 2003, Santa Clara
The only event dedicated to issues related to Linux enterprise solutions
www.enterpriselinuxforum.com
#1 lore raw
Quoted 15 lines

I put 'modprobe snd-hammerfall-mem enable=1' as the first thing that happens in /etc/rc.sysinit. It doesn't seem to allocate any memory. When the machine first boots with the PCMCIA card in, it lists it as this:

$ lspci
...
01:00.0 Class ffff: Illegal Vendor ID: Unknown device ffff (rev ff)

If I remove the card with cardctl eject and put it back in, it shows up.

$ lspci
...
01:00.0 Multimedia audio controller: Xilinx, Inc. RME Hammerfall DSP
(rev 0b)
Quoted 7 lines

At this point I can reload snd-hammerfall-mem and snd-hdsp and they don't complain. The bright red HOST light is still on though. Of course, at this point, it is probably too late for snd-hammerfall-mem to have been loaded correctly.

Does the enable argument to snd-hammerfall-mem do anything anymore? Any other ideas?

it didn't work because of the erroneous PCI ID that appeared for the h/w. the hammerfall-mem module counts how many Hammerfall-ish devices it can find, and allocates memory for them. a device claiming to be vendor 0xffff is not only illegal, its definitely not a hammerfall :)

--p

-------------------------------------------------------
Enterprise Linux Forum Conference & Expo, June 4-6, 2003, Santa Clara The only event dedicated to issues related to Linux enterprise solutions www.enterpriselinuxforum.com