hdc: lost interrupt ide-cd: cmd 0x3 timed out with 2.6.6-rc3-bk8
Quoted 1 line
zero IDE changes in bk6 -> bk8 but a lot of ACPI / IRQ related
OK. My APIC is a SiS961.
I can't send data from 2.6.6-rc3-bk8, but from 2.6.6-rc3-bk6, /proc/acpi gives:
(/proc/acpi/processor/CPU0)
processor id: 0 acpi id: 0 bus mastering control: yes power management: no throttling control: no limit interface: no <not supported> active state: C1 default state: C1 bus master activity: 00000000
states:
*C1: promotion[--] demotion[--] latency[000]
usage[00000000]
C2: <not supported>
C3: <not supported>
<not supported>
cat /proc/acpi/sleep shows:
S0 S1 S4 S5
cat /proc/ide/sis shows:
SiS 5513 Ultra 100 chipset
--------------- Primary Channel ---------------- Secondary Channel
-------------
Channel Status: On On
Operation Mode: Compatible Compatible
Cable Type: 80 pins 80 pins
Prefetch Count: 512 512
Drive 0: Postwrite Enabled Postwrite Disabled
Prefetch Enabled Prefetch Disabled
UDMA Enabled UDMA Enabled
UDMA Cycle Time 3 CLK UDMA Cycle Time 6CLK
Data Active Time 3 PCICLK Data Active Time 3
PCICLK
Data Recovery Time 1 PCICLK Data Recovery Time 1
PCICLK
Drive 1: Postwrite Enabled Postwrite Disabled
Prefetch Enabled Prefetch Disabled
UDMA Enabled UDMA Disabled
UDMA Cycle Time 2 CLK UDMA Cycle Time Reserved
Data Active Time 3 PCICLK Data Active Time 3
PCICLK
Data Recovery Time 1 PCICLK Data Recovery Time 3
PCICLK
... I don't know if any of this is helpful. The IRQ and IO address assignments (sent with my first email) are from 2.6.6-rc3-bk6.
Thanks,
Bob
Re: hdc: lost interrupt ide-cd: cmd 0x3 timed out ...
Quoted 1 line
Quoted 1 line
zero IDE changes in bk6 -> bk8 but a lot of ACPI / IRQ related
it's bk8 which broke sis961 (or revealed it native brokenness)
Quoted 1 line
OK. My APIC is a SiS961.
I have the same problem (and the same chipset).
Passing acpi=noirq helps to work it around.
Re: hdc: lost interrupt ide-cd: cmd 0x3 timed out ...
OK, great! Adding acpi=noirq to the kernel line made the lost interrupt problem go away, and getting rid of rhgb on the same line made the problems I had with nvidia drivers killing the system at the login prompt (white screen, no kbd response) go away.
One goes in, one goes out! ;)
Thanks,
Bob
Quoted 9 lines · Alex Riesen
Quoted 1 line
Quoted 1 line
zero IDE changes in bk6 -> bk8 but a lot of ACPI / IRQ related
it's bk8 which broke sis961 (or revealed it native brokenness)
Quoted 1 line
OK. My APIC is a SiS961.
I have the same problem (and the same chipset).
Passing acpi=noirq helps to work it around.