Skip to contentSkip to conversation

Load Balance sim ply doesn´t work...

LARTC [email protected] 1 participant 1 message Aug 27, 2004

lore
Share & tools
lore
#0 lore raw
Quoted 2 lines
Quoted 2 lines

ip route add default scope global nexthop via $P1 dev

$IF1 weight 1 \

Quoted 8 lines
Quoted 2 lines

nexthop via $P2 dev $IF2 weight 1

This multipath routing command keep coming up as classic way to perform multipath routing for NAT access, which I considered it as VERY misleading.

It should only be used if you are NOT using NAT.

You mean that using NAT its impossible to do load balance or this is the worng command? If its the wrong command, what´s the right one?
Tks A LOT for the response!
Fernando Favero
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/