: General code modi [...]
PATCH v3 1/10 : General code modi [...]
Hello list,
inside the automatic U-Boot patch tracking system a new ticket [DNX#2006110242000038] was created:
<snip>
Quoted 99 lines
General code modification for mpc7448hpc2 board support.
1. Add 7447A and 7448 processor support.
2. Add the following flags.
CFG_CONFIG_BUS_CLK: If the 74xx bus frequency can be configured dynamically (such as by switch on board), this flag should be set.
CFG_EXCEPTION_AFTER_RELOCATE: If an exception occurs after the u-boot relocates to RAM, this flag should be set
CFG_SERIAL_HANG_IN_EXCEPTION: If the print out function will cause the system hang in exception, this flag should be setThere is a design issue for tsi108/109 pci configure read. When pci scan the slots, if there is no pci card, the tsi108/9 will cause a machine check exception for mpc7448 processor.
Signed-off-by Alexandre Bounine <[email protected]>Signed-off-by Roy Zang <[email protected]>--- MAKEALL | 4 +-- Makefile | 3 ++ README | 22 ++++++++-------- cpu/74xx_7xx/cpu.c | 54 +++++++++++++++++++++++++++++++++++++--- cpu/74xx_7xx/cpu_init.c | 2 + cpu/74xx_7xx/speed.c | 55 ++++++++++++++++++++++++++++++++++++++--- drivers/Makefile | 6 ++-- include/74xx_7xx.h | 1 + include/asm-ppc/global_data.h | 3 ++ lib_ppc/extable.c | 10 +++++++ 10 files changed, 136 insertions(+), 24 deletions(-)MAKEALL +2
-2@@ -150,8 +150,8 @@ ## 74xx/7xx Systems ######################################################################### LIST_74xx=" \ - DB64360 DB64460 EVB64260 P3G4 \ - PCIPPC2 PCIPPC6 ZUMA \ + DB64360 DB64460 EVB64260 mpc7448hpc2 \ + P3G4 PCIPPC2 PCIPPC6 ZUMA \ " LIST_7xx=" \Makefile +3
-0@@ -1718,6 +1718,9 @@ EVB64260_config \ EVB64260_750CX_config: unconfig @$(MKCONFIG) EVB64260 ppc 74xx_7xx evb64260 +mpc7448hpc2_config: unconfig + @./mkconfig $(@:_config=) ppc 74xx_7xx mpc7448hpc2 + P3G4_config: unconfig @$(MKCONFIG) $(@:_config=) ppc 74xx_7xx evb64260README +11
-11@@ -2312,17 +2312,17 @@ configurations; the following names are csb272_config lwmon_config sbc8260_config CU824_config MBX860T_config sbc8560_33_config DUET_ADS_config MBX_config sbc8560_66_config - EBONY_config MPC8260ADS_config SM850_config - ELPT860_config MPC8540ADS_config SPD823TS_config - ESTEEM192E_config MPC8540EVAL_config stxgp3_config - ETX094_config MPC8560ADS_config SXNI855T_config - FADS823_config NETVIA_config TQM823L_config - FADS850SAR_config omap1510inn_config TQM850L_config - FADS860T_config omap1610h2_config TQM855L_config - FPS850L_config omap1610inn_config TQM860L_config - omap5912osk_config walnut_config - omap2420h4_config Yukon8220_config - ZPC1900_config + EBONY_config mpc7448hpc2_config SM850_config + ELPT860_config MPC8260ADS_config SPD823TS_config + ESTEEM192E_config MPC8540ADS_config stxgp3_config + ETX094_config MPC8540EVAL_config SXNI855T_config + FADS823_config NMPC8560ADS_config TQM823L_config + FADS850SAR_config NETVIA_config TQM850L_config + FADS860T_config omap1510inn_config TQM855L_config + FPS850L_config omap1610h2_config TQM860L_config + omap1610inn_config walnut_config + omap5912osk_config Yukon8220_config + omap2420h4_config ZPC1900_config Note: for some board special configuration names may exist; check if additional information is available from the board vendor; forcpu/74xx_7xx/cpu.c +0
-0
cpu/74xx_7xx/cpu.c
Quoted 1 line
cpu/74xx_7xx/cpu.c +0
-1--- a/cpu/74xx_7xx/cpu.c
</snip>
Your U-Boot support team