Skip to contentSkip to conversation

HDA Power management.

DISCUSSION Tobin Davis 2 participants 2 messages Aug 5, 2008 – Aug 6, 2008

lore
Share & tools
lore
#0 lore raw

Ok, I've been studying the code for a couple of weeks now, and testing on a mobile type development platform with a Realtek ALC262, but I have not been able to get the audio codec to enter low power mode (D3). I can see it switch when running that other OS. When running, the chip draws ~400mw, but drops to 40mw after switching to low power mode. How do I get it to do the same with the current driver? I'm using the git tip for alsa, and 2.6.26 final kernel.

I have tried setting the power mode to D3 using the hda-tool from Takashi, but the codec reverts to D0 (full power) after a second or two, even though there is nothing touching the audio in my test environment.

Signature · 4 lines
Tobin Davis 


The beauty of a pun is in the "Oy!" of the beholder.
#1 lore raw

At Tue, 05 Aug 2008 15:13:36 -0700,

Quoted 11 lines · Tobin Davis

Ok, I've been studying the code for a couple of weeks now, and testing on a mobile type development platform with a Realtek ALC262, but I have not been able to get the audio codec to enter low power mode (D3). I can see it switch when running that other OS. When running, the chip draws ~400mw, but drops to 40mw after switching to low power mode. How do I get it to do the same with the current driver? I'm using the git tip for alsa, and 2.6.26 final kernel.

I have tried setting the power mode to D3 using the hda-tool from Takashi, but the codec reverts to D0 (full power) after a second or two, even though there is nothing touching the audio in my test environment.

Could you show alsa-info output? I guess some loopback switches are turned on that prevent the power-down.

Takashi