Skip to contentSkip to conversation

docs: correct gpio.txt typos

PATCH David Brownell 1 participant 1 message Dec 8, 2009 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 8 lines · Randy Dunlap

From: Dominik D. Geyer <[email protected]>
Subject: correct gpio.txt typos

Corrected sysfs gpio chip node name and fixed punctuation.

Ack.

Quoted 29 lines
---
 Documentation/gpio.txt |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
Documentation/gpio.txt +2 -2
@@ -380,7 +380,7 @@ rare; use gpiochip_remove() when it is u
 
 Most often a gpio_chip is part of an instance-specific structure with state
 not exposed by the GPIO interfaces, such as addressing, power management,
-and more.  Chips such as codecs will have complex non-GPIO state,
+and more.  Chips such as codecs will have complex non-GPIO state.
 
 Any debugfs dump method should normally ignore signals which haven't been
 requested as GPIOs.  They can use gpiochip_is_requested(), which returns
@@ -531,7 +531,7 @@ and have the following read/write attrib
 		This file exists only if the pin can be configured as an
 		interrupt generating input pin.
 
-GPIO controllers have paths like /sys/class/gpio/chipchip42/ (for the
+GPIO controllers have paths like /sys/class/gpio/gpiochip42/ (for the
 controller implementing GPIOs starting at #42) and have the following
 read-only attributes:
 
Signature · 1 line
--