ALSA: ASoC: cs4271: add DT property for AMUTEB=BMUTEC feature
Subsystems (4)
PATCH 1/1 ALSA: ASoC: cs4271: add DT property for AMUTEB=BMUTEC feature
The CS4271 has a feature to sync its analog mute flags, so one mute circuitry can be used for both channels.
Give DT uses access to this feature with a new property.
--- Documentation/devicetree/bindings/sound/cs4271.txt | 2 ++ sound/soc/codecs/cs4271.c | 13 ++++++++++++- 2 files changed, 14 insertions(+), 1 deletion(-)
Documentation/devicetree/bindings/sound/cs4271.txt +2 -0
@@ -18,6 +18,8 @@ Optional properties: - reset-gpio: a GPIO spec to define which pin is connected to the chip's !RESET pin + - cirrus,amuteb-eq-bmutec: When given, the Codec's AMUTEB=BMUTEC flag + is enabled. Examples:
sound/soc/codecs/cs4271.c +12 -1
@@ -474,11 +474,17 @@ static int cs4271_probe(struct snd_soc_codec *codec)struct cs4271_platform_data *cs4271plat = codec->dev->platform_data;int ret;int gpio_nreset = -EINVAL ; +int amutec_eq_bmutec =0 ;#ifdef CONFIG_OF -if (of_match_device (cs4271_dt_ids, codec->dev)) +if (of_match_device (cs4271_dt_ids, codec->dev)) { gpio_nreset =of_get_named_gpio (codec->dev->of_node,"reset-gpio" ,0 ); + +if (!of_get_property (codec->dev->of_node, +"cirrus,amutec-eq-bmutec" ,NULL )) + amutec_eq_bmutec =1 ; + }#endif if (cs4271plat &&gpio_is_valid (cs4271plat->gpio_nreset))
@@ -528,6 +534,11 @@ static int cs4271_probe(struct snd_soc_codec *codec)/* Power-up sequence requires 85 uS */ udelay (85 ); +if (amutec_eq_bmutec) +snd_soc_update_bits (codec,CS4271_MODE2 , +CS4271_MODE2_MUTECAEQUB , +CS4271_MODE2_MUTECAEQUB ); +return snd_soc_add_codec_controls (codec, cs4271_snd_controls,ARRAY_SIZE (cs4271_snd_controls)); }
Signature · 1 line
1.7.11.4
Quoted 4 lines · Daniel Mack
The CS4271 has a feature to sync its analog mute flags, so one mute circuitry can be used for both channels.
Give DT uses access to this feature with a new property.
Is there some reason not to add this to the platform data while we're at it?
Quoted 9 lines · Mark Brown
Quoted 4 lines · Daniel Mack
The CS4271 has a feature to sync its analog mute flags, so one mute circuitry can be used for both channels.
Give DT uses access to this feature with a new property.
Is there some reason not to add this to the platform data while we're at it?
Well, no :) Can do that, just a sec.
Daniel