mx28evk: Disable CONFIG_CMD_I2C
PATCH 1/1 mx28evk: Disable CONFIG_CMD_I2C
From: Fabio Estevam <[email protected]>
When loading a Freescale 2.6.35 on a mx28evk the following issue is seen:
sgtl5000_hw_read: read reg error : Reg 0x00
Device with ID register 0 is not a SGTL5000
Disabling CONFIG_CMD_I2C makes the sgtl5000 probe to succeed.
Mainline kernel does not show this problem.
Until the real cause is not identified, disable 'CONFIG_CMD_I2C' for the time being.
---
Stefano,
Since 2013.04 is approaching I prefer to disable this option until the real cause is identified.
This patch applies on top of http://patchwork.ozlabs.org/patch/225950/
include/configs/mx28evk.h | 1 - 1 file changed, 1 deletion(-)
include/configs/mx28evk.h +0 -1
@@ -68,7 +68,6 @@#define CONFIG_CMD_SPI #define CONFIG_CMD_USB #define CONFIG_CMD_BOOTZ -#define CONFIG_CMD_I2C #define CONFIG_CMD_NAND /*
Signature · 1 line
1.7.9.5
PATCH 1/1 mx28evk: Disable CONFIG_CMD_I2C
Quoted 32 lines · Fabio Estevam
From: Fabio Estevam <[email protected]>
When loading a Freescale 2.6.35 on a mx28evk the following issue is seen:
sgtl5000_hw_read: read reg error : Reg0x00
Device with ID register 0 is not a SGTL5000Disabling
CONFIG_CMD_I2Cmakes the sgtl5000 probe to succeed.Mainline kernel does not show this problem.
Until the real cause is not identified, disable '
CONFIG_CMD_I2C' for the time being.Signed-off-by Fabio Estevam <[email protected]>---
Stefano,Since 2013.04 is approaching I prefer to disable this option until the real cause is identified.
This patch applies on top of http://patchwork.ozlabs.org/patch/225950/
include/configs/mx28evk.h | 1 - 1 file changed, 1 deletion(-)include/configs/mx28evk.h +0
-0
include/configs/mx28evk.h line 73
Quoted 7 lines
include/configs/mx28evk.h +0
-1@@ -68,7 +68,6 @@#define CONFIG_CMD_SPI #define CONFIG_CMD_USB #define CONFIG_CMD_BOOTZ -#define CONFIG_CMD_I2C #define CONFIG_CMD_NAND /*
Applied to u-boot-imx, thanks.
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================