usb: remove unnecessary CONFIG_PM dependency from USB_OTG
PATCH v3 1/1 usb: remove unnecessary CONFIG_PM dependency from USB_OTG
The USB OTG support currently depends on power management (CONFIG_PM) being enabled, but does not actually need it enabled. Remove this dependency.
Remove the unneeded "default n" from USB_OTG as well, the default is already n.
Tested on Bay Trail hardware with dwc3 USB.
--- drivers/usb/core/Kconfig | 2 -- 1 file changed, 2 deletions(-)
drivers/usb/core/Kconfig +0 -2
@@ -43,8 +43,6 @@ config USB_DYNAMIC_MINORS config USB_OTG bool "OTG support" - depends on PM - default n help The most notable feature of USB OTG is support for a "Dual-Role" device, which can act as either a device
Signature · 1 line
1.7.10.4
Quoted 6 lines · Nathan Sullivan
The USB OTG support currently depends on power management (
CONFIG_PM) being enabled, but does not actually need it enabled. Remove this dependency.Remove the unneeded "default n" from
USB_OTGas well, the default is already n.
I prefer not to remove it, since most of people may not want to enable it, you can grep the Kconfig in the kernel source, there are lots of "default n", especially, it can indicate people that if they are not sure, set 'n' for it.
Peter
Quoted 22 lines
Tested on Bay Trail hardware with dwc3 USB.
Signed-off-by Nathan Sullivan <[email protected]>--- drivers/usb/core/Kconfig | 2 -- 1 file changed, 2 deletions(-)drivers/usb/core/Kconfig +0
-2@@ -43,8 +43,6 @@ config USB_DYNAMIC_MINORS config USB_OTG bool "OTG support" - depends on PM - default n help The most notable feature of USB OTG is support for a "Dual-Role" device, which can act as either a device
Signature · 2 lines
Best Regards, Peter Chen