Skip to contentSkip to conversation

hwmon: (it87) Enhance validation for fan4 and fan5

PATCH In review Guenter Roeck 1 participant 1 message Jan 27, 2016

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH v3 22/25 hwmon: (it87) Enhance validation for fan4 and fan5

From: Guenter Roeck <[email protected]>

Several of the chips supported by this driver have a configuration register to enable fan4 and fan5. Use those registers to determine if fan4 and fan5 tachometers are supported.

---
 drivers/hwmon/it87.c | 23 +++++++++++++++++++++++
 1 file changed, 23 insertions(+)
drivers/hwmon/it87.c +23 -0
index f40d81a0a9fc..5adb269918fb 100644
@@ -2415,6 +2415,29 @@ static int __init it87_find(int sioaddr, unsigned short *address,
 
 		superio_select(sioaddr, GPIO);
 
+		/* Check for fan4, fan5 */
+		if (has_five_fans(config)) {
+			reg = superio_inb(sioaddr, IT87_SIO_GPIO2_REG);
+			switch (sio_data->type) {
+			case it8718:
+				if (reg & BIT(5))
+					sio_data->skip_fan |= BIT(3);
+				if (reg & BIT(4))
+					sio_data->skip_fan |= BIT(4);
+				break;
+			case it8720:
+			case it8721:
+			case it8728:
+				if (!(reg & BIT(5)))
+					sio_data->skip_fan |= BIT(3);
+				if (!(reg & BIT(4)))
+					sio_data->skip_fan |= BIT(4);
+				break;
+			default:
+				break;
+			}
+		}
+
 		reg = superio_inb(sioaddr, IT87_SIO_GPIO3_REG);
 		if (!sio_data->skip_vid) {
 			/* We need at least 4 VID pins */
Signature · 7 lines
2.1.4


_______________________________________________
lm-sensors mailing list
[email protected]
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors