Skip to contentSkip to conversation

issues loading a FIT image with bootm

DISCUSSION Kai Che 2 participants 2 messages Oct 29, 2018

lore
Share & tools
lore

Kai Che

author
#0 lore raw

Hi all,

I'm trying to load a FIT image (image.itb) with the bootm command, but I'm getting the following issue:

barebox@RaspberryPi 3 Model B:/ bootm
Loading open firmware Device Tree flattened Binary '/mnt/disk0.3/image.itb' no image handler found for image type open firmware Device Tree flattened Binary handler failed with: No such device

The generated .itb file is created with mkimage -f from u-boot and according to the patches, the FIT image format should be supported:

http://lists.infradead.org/pipermail/barebox/2015-March/022876.html

Does anyone have experience with loading and verifying FIT images with bootm and could give me some suggestions on what would I need to check further in order to identify and fix the issue?

Thanks,
Kai
_______________________________________________
barebox mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/barebox

#1 lore raw

Hi Kai,

Quoted 7 lines · Kai Che

Hi all,

I'm trying to load a FIT image (image.itb) with the bootm command, but I'm getting the following issue:

barebox@RaspberryPi 3 Model B:/ bootm
Loading open firmware Device Tree flattened Binary '/mnt/disk0.3/image.itb' no image handler found for image type open firmware Device Tree flattened Binary

This sounds like you have CONFIG_FITIMAGE or CONFIG_BOOTM_FITIMAGE disabled.

Sascha

Signature · 9 lines
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |

_______________________________________________
barebox mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/barebox