mmc: fsl_esdhc_imx: add wait_dat0() support
Subsystems (2)
PATCH v2 1/1 mmc: fsl_esdhc_imx: add wait_dat0() support
From: Haibo Chen <[email protected]>
Add wait_dat0() support, upper layer will use this callback.
Signed-off-by Haibo Chen <[email protected]>
--- drivers/mmc/fsl_esdhc_imx.c | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+)
drivers/mmc/fsl_esdhc_imx.c +23 -0
@@ -1646,6 +1646,28 @@ static int fsl_esdhc_set_enhanced_strobe(struct udevice *dev) }#endif +static int fsl_esdhc_wait_dat0 (struct udevice *dev,int state, +int timeout_us) +{ +int ret = -ETIMEDOUT ; +bool dat0_high; +bool target_dat0_high = !!state; +struct fsl_esdhc_priv *priv =dev_get_priv (dev); +struct fsl_esdhc *regs = priv->esdhc_regs; + + timeout_us =DIV_ROUND_UP (timeout_us,10 );/* check every 10 us. */ +while (timeout_us--) { + dat0_high = !!(esdhc_read32 (®s->prsstat) &PRSSTAT_DAT0 ); +if (dat0_high == target_dat0_high) { + ret =0 ; +break ; + } +udelay (10 ); + } + +return ret; +} +static const struct dm_mmc_ops fsl_esdhc_ops = { .get_cd = fsl_esdhc_get_cd, .send_cmd = fsl_esdhc_send_cmd,
@@ -1656,6 +1678,7 @@ static const struct dm_mmc_ops fsl_esdhc_ops = {#if CONFIG_IS_ENABLED (MMC_HS400_ES_SUPPORT ) .set_enhanced_strobe = fsl_esdhc_set_enhanced_strobe, #endif + .wait_dat0 = fsl_esdhc_wait_dat0, };#endif
Signature · 1 line
2.17.1