Skip to contentSkip to conversation

Bus Speed

parisc-linux marc 3 participants 3 messages Sep 7, 2002

lore
Share & tools
lore

marc

author
#0 lore raw

When Linux starts up I see a message saying:

ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx

I have a C180 and the bus speed at startup says:

Central Bus Speed (in MHz) : 120

so I'm assuming I should add the boot parameter as mentioned above. Will I see any performance gain?

Thanks,
-Marc

#1 lore raw
Quoted 10 lines · marc

When Linux starts up I see a message saying:

ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx

I have a C180 and the bus speed at startup says:

Central Bus Speed (in MHz) : 120

so I'm assuming I should add the boot parameter as mentioned above. Will I see any performance gain?

I doubt the 120Mhz clock is run to non PCI IDE devices. The PARISC port should be setting the IDE base clocking itself.

#2 lore raw
In reply to marc
Quoted 3 lines · marc

ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx I have a C180 and the bus speed at startup says:
Central Bus Speed (in MHz) : 120

There is no IDE on C180 unless you've added a PCI card that has it. Only systems with SuckyIO have built-in IDE where HPUX officially only supports CD-ROM. Of course, under linux we can do what we want.

"Central Bus" in this case is the "Runway" bus.
Only CPU, Memory Controller and IO Controller (U2) are on Runway bus.

grant