Bus Speed
When Linux starts up I see a message saying:
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
I have a C180 and the bus speed at startup says:
Central Bus Speed (in MHz) : 120
so I'm assuming I should add the boot parameter as mentioned above. Will I see any performance gain?
Thanks,
-Marc
Quoted 10 lines · marc
When Linux starts up I see a message saying:
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
I have a C180 and the bus speed at startup says:
Central Bus Speed (in MHz) : 120
so I'm assuming I should add the boot parameter as mentioned above. Will I see any performance gain?
I doubt the 120Mhz clock is run to non PCI IDE devices. The PARISC port should be setting the IDE base clocking itself.
Quoted 3 lines · marc
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx I have a C180 and the bus speed at startup says:
Central Bus Speed (in MHz) : 120
There is no IDE on C180 unless you've added a PCI card that has it. Only systems with SuckyIO have built-in IDE where HPUX officially only supports CD-ROM. Of course, under linux we can do what we want.
"Central Bus" in this case is the "Runway" bus.
Only CPU, Memory Controller and IO Controller (U2) are on Runway bus.
grant