Skip to contentSkip to conversation

HPT366 ate my IDE controllers

DISCUSSION Rahsheen Porter Sr. 2 participants 2 messages Dec 5, 2003

lore
Share & tools
lore
#0 lore raw

When I boot 2.6.0test11 on my Abit BP6, it *only* sees the HPT366 controllers. The other 2 controllers built in to the mobo don't show up at all. All I see is what's plugged into the 2 HPT366 controllers.

So my root partition, which resides on /dev/hde1 with 2.4.20, becomes /dev/hda1. And my extra partitions that were on /dev/hdg are on /dev/hdc. This wouldn't be a problem accept that what was on /dev/hda and hdc are now gone.

What would cause the kernel to totally ignore the built in controllers?

Signature · 1 line
Rahsheen Porter	<[email protected]>
#1 lore raw
Quoted 5 lines · Rahsheen Porter Sr.

When I boot 2.6.0test11 on my Abit BP6, it *only* sees the HPT366 controllers. The other 2 controllers built in to the mobo don't show up at all. All I see is what's plugged into the 2 HPT366 controllers.

Quoted 7 lines

So my root partition, which resides on /dev/hde1 with 2.4.20, becomes /dev/hda1. And my extra partitions that were on /dev/hdg are on /dev/hdc. This wouldn't be a problem accept that what was on /dev/hda and hdc are now gone.

What would cause the kernel to totally ignore the built in controllers?

I'd bet a small amount that there is something in the bios you've set that is making that decision for you. Probably a boot offboard controllers first or some such.

Signature · 7 lines
Cheers, Gene
AMD K6-III@500mhz 320M
Athlon1600XP@1400mhz  512M
99.27% setiathome rank, not too shabby for a WV hillbilly
Yahoo.com attornies please note, additions to this message
by Gene Heskett are:
Copyright 2003 by Maurice Eugene Heskett, all rights reserved.