Skip to contentSkip to conversation

scp running too slow

DISCUSSION Pavel Machek 2 participants 3 messages Feb 28, 2004

lore
Share & tools
lore
#0 lore raw

Hi!

I'm copying huge file from x86-64 machine to i386.

x86-64 is running 2.6.3-bk, today from Linus' cvs. tg3 driver. It shows pretty high CPU load (like 98% CPU), and is not even able to reach 1MB/sec. When x86-64 machine was running 2.4, I was able to get

Quoted 1 line

4MB/sec...

Any ideas?

Pavel

Signature · 2 lines
When do you have a heart between your knees?
[Johanka's followup: and *two* hearts?]
#1 lore raw

Hi!

Quoted 8 lines

I'm copying huge file from x86-64 machine to i386.

x86-64 is running 2.6.3-bk, today from Linus' cvs. tg3 driver. It shows pretty high CPU load (like 98% CPU), and is not even able to reach 1MB/sec. When x86-64 machine was running 2.4, I was able to get

Quoted 1 line

4MB/sec...

Any ideas?

Okay, probably my fault. That machine is running in PIO mode, and log was full of hda: lost interrupt; which explains poor performance. I need to enable chipset-specific dma support in kernel config.

Pavel

Signature · 2 lines
When do you have a heart between your knees?
[Johanka's followup: and *two* hearts?]
#2 lore raw
In reply to Pavel Machek
Quoted 8 lines · Pavel Machek

Hi!

I'm copying huge file from x86-64 machine to i386.

x86-64 is running 2.6.3-bk, today from Linus' cvs. tg3 driver. It shows pretty high CPU load (like 98% CPU), and is not even able to reach 1MB/sec. When x86-64 machine was running 2.4, I was able to get

Quoted 1 line

4MB/sec...

Could you provide slightly more data? like the output of vmstat 1 or a tcpdump. Also, is a transfer going the other way faster, does -C none help etc.

Signature · 2 lines
http://www.PowerDNS.com      Open source, database driven DNS Software 
http://lartc.org           Linux Advanced Routing & Traffic Control HOWTO