snd-powermac volume setting broken?
When I use alsa snd-powermac driver, the lowest volume setting (but without muting) is at about half of full volume, it's impossible to get any volume level between mute and vol=0. Is that a bug or a feature?
Signature · 3 lines
Witold Kręcicki (adasi) adasi [at] culm.net GPG key: 7AE20871 http://www.culm.net
Quoted 3 lines · Witold Krecicki
When I use alsa snd-powermac driver, the lowest volume setting (but without muting) is at about half of full volume, it's impossible to get any volume level between mute and vol=0. Is that a bug or a feature?
Just a me too
This happens in the change from 2.6.4-rc1 to 2.6.4-rc2
I have checked the changelog and there is no change in the sound section (perhaps a change in timer.c?)
Best regards
--
Celso Gonzalez
At Sat, 13 Mar 2004 00:15:17 +0100,
Quoted 4 lines · Witold Krecicki
When I use alsa snd-powermac driver, the lowest volume setting (but without muting) is at about half of full volume, it's impossible to get any volume level between mute and vol=0. Is that a bug or a feature?
not a bug - the chip doesn't support the level below vol=0 and it's not totally silent.
Takashi
Dnia poniedziałek 15 marzec 2004 11:07, napisałeś:
Quoted 9 lines
At Sat, 13 Mar 2004 00:15:17 +0100,
Quoted 3 lines · Witold Krecicki
When I use alsa snd-powermac driver, the lowest volume setting (but without muting) is at about half of full volume, it's impossible to get any volume level between mute and vol=0. Is that a bug or a feature?
not a bug - the chip doesn't support the level below vol=0 and it's not totally silent.
but it's not like 'not totally silent' but 'pretty loud'. On OSX volume scale is just fine.
Signature · 3 lines
Witold Kręcicki (adasi) adasi [at] culm.net GPG key: 7AE20871 http://www.culm.net
At Mon, 15 Mar 2004 11:12:21 +0100,
Quoted 5 lines · Witold Krecicki
Dnia poniedziałek 15 marzec 2004 11:07, napisałeś:
Quoted 3 lines
At Sat, 13 Mar 2004 00:15:17 +0100,
Witold Krecicki wrote:
Quoted 8 lines
Quoted 6 lines
Quoted 3 lines
When I use alsa snd-powermac driver, the lowest volume setting (but without muting) is at about half of full volume, it's impossible to get any volume level between mute and vol=0. Is that a bug or a feature?
not a bug - the chip doesn't support the level below vol=0 and it's not totally silent.
but it's not like 'not totally silent' but 'pretty loud'. On OSX volume scale is just fine.
ok, my comment was a rough guess which i experienced once (IIRC, it was a screamer). so let me know the chipset on your machine, shown in /proc/asound/cards. if it's tumbler or snapper, this behavior should be a bug of the driver.
Takashi