Skip to contentSkip to conversation

MARK target question

LARTC Peter Rabbitson 3 participants 3 messages May 9, 2004 – May 10, 2004

lore
Share & tools
lore
#0 lore raw

This is more of a NF question but it is tightly related to LARTC as well. In the following example:

-t mangle -A PREROUTING -i eth0 -j MARK 0x1
....
-t mangle -A INPUT -i eth0 -j MARK 0x2

Since MARK is a non-terminatring target, what would be the resulting mark on a packet comming from the outside and destined for a local process?

Thanks

P.S. I agree, the example looks stupid, but on the other hand the real life case where this situation occurs is rather confusing and therefore not very suitable.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 9 lines · Peter Rabbitson

This is more of a NF question but it is tightly related to LARTC as well. In the following example:

(quoted diff) +0 -2
-t mangle -A PREROUTING -i eth0 -j MARK 0x1
....
-t mangle -A INPUT -i eth0 -j MARK 0x2

Since MARK is a non-terminatring target, what would be the resulting mark on a packet comming from the outside and destined for a local process?

INPUT is after PREROUTING, so 0x2.
See
http://www.docum.org/stef.coene/qos/kptd/

Stef

Signature · 6 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#2 lore raw
In reply to Peter Rabbitson
Quoted 8 lines · Peter Rabbitson

This is more of a NF question but it is tightly related to LARTC as well. In the following example:

(quoted diff) +0 -2
-t mangle -A PREROUTING -i eth0 -j MARK 0x1
....
-t mangle -A INPUT -i eth0 -j MARK 0x2

Since MARK is a non-terminatring target, what would be the resulting mark on a packet comming from the outside and destined for a local process?

The mark would be 0 until the packet hits the first rule. After that, it would be 1 through the remainder of the PREROUTING chains. After routing, it would pass to the INPUT chains where it would change to 2 when it hits the second rule and would remain 2 through the rest of the INPUT chains.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/