Skip to contentSkip to conversation

Problems during board configuration of U-boot1.1.2!

U-Boot-Users liangdongzhou liangdongzhou 2 participants 2 messages Feb 20, 2005

lore
Share & tools
lore
#0 lore raw

I had just been in porting U-Boot1.1.2 to AMCC's Bubinga405ep Eval board.But after I had generated PPC_4xx-gcc cross-compiler and do board configuring,some problems appeared on the screen:
[root at sunriver u-boot]#make bubinga405ep_config

make:*** No rule to make target"bubinga405ep_config".
Stop

I don't know what's wrong with the u-boot,for I had checked the config.h and no errors found.Help me pls!

James.Zhou

__________________________________
Do you Yahoo!?
The all-new My Yahoo! - What will yours do?
http://my.yahoo.com

#1 lore raw

Why are you posting the same question twice within just 3 minutes?

Quoted 2 lines · In message <[email protected]> you wrote:

I had just been in porting U-Boot1.1.2 to AMCC's
Bubinga405ep Eval board.But after I had generated

I don't understand why you should have to do any porting - the Bubinga board is fully supported in U-Boot. You just have to build it.

Quoted 4 lines

make:*** No rule to make target"bubinga405ep_config".
Stop

I don't know what's wrong with the u-boot,for I had

Please get used to the fact that Unix is case-sensitive - check the Makefile if you are in doubt about the correct spelling. In this case, please try:

	$ make BUBINGA405EP_config ; make

Best regards,

Wolfgang Denk

Signature · 3 lines
See us @ Embedded World, Nuremberg, Feb 22 - 24,  Hall 10.0 Booth 310
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The greatest threat towards future is indifference.