Skip to contentSkip to conversation

ATAPI DVD Drive looses dma settings on reset, keepsettings=1

DISCUSSION Rashkae 1 participant 1 message Jan 12, 2006

lore
Share & tools
lore

Rashkae

author
#0 lore raw

Tested with Linux 2.6.15 and 2.6.13.3

I have an ATAPI DVD drive as a master(single) device on my secondary IDE (hdc).

The normal hdparm settings are:
IO_support = 1 (32-bit)

 unmaskirq    =  1 (on)
 using_dma    =  1 (on)
 keepsettings =  1 (on)
 readonly     =  0 (off)

readahead = 256 (on)

However, if I force a reset with hdparm -w (or the Kernel does when I insert a disc that the drive takes too long to identify), DMA gets turned off. Dmesg reports:

hdc: DMA disabled
hdc: ATAPI reset complete

In the case where inserting a disc causes the reset, dmesg reports:

hdc: irq timeout: status=0xd0 { Busy }
ide: failed opcode was: unknown
hdc: DMA disabled
hdc: ATAPI reset complete

Is there a way I can increate the irq timeout?

It was my understanding that with keepsettings on, the driver would retain the dma setting on reset. If there is a way correct this, or I have mis-understood the purpose of keepsettings, please CC me the response.

Thanks.