Skip to contentSkip to conversation

snd_hda_intel on 2.6.16

DISCUSSION Alejandro Bonilla 3 participants 8 messages Mar 31, 2006

lore
Share & tools
lore
#0 lore raw

Hi,

I read about a problem with snd_hda_intel latelly on 2.6.16. I was not having this on 2.6.15-19 but looks like it is "chip-monking"

I use linux2.6 git and it is still present. Just wanted to let you'll know about it.

Should anyone need any info, please let me know.

.Alejandro

#1 lore raw
Quoted 5 lines · Alejandro Bonilla

Hi,

I read about a problem with snd_hda_intel latelly on 2.6.16. I was not having this on 2.6.15-19 but looks like it is "chip-monking"

Too cryptic. What exactly is the problem?

Quoted 5 lines

I use linux2.6 git and it is still present. Just wanted to let you'll know about it.

Should anyone need any info, please let me know.

Well, for starters, your hardware info ("hda-intel" describes 1000s of slightly different devices).

Does it work with the latest ALSA CVS or 1.0.11-rc4?

Lee

#2 lore raw

On Fri, 31 Mar 2006 11:40:58 -0500, Lee Revell wrote

Quoted 8 lines · Alejandro Bonilla
Quoted 5 lines

Hi,

I read about a problem with snd_hda_intel latelly on 2.6.16. I was not having this on 2.6.15-19 but looks like it is "chip-monking"

Too cryptic. What exactly is the problem?

The sound is like at 1.2x. Just a little bit faster but noticeable.

Quoted 9 lines
Quoted 6 lines

I use linux2.6 git and it is still present. Just wanted to let you'll know about it.

Should anyone need any info, please let me know.

Well, for starters, your hardware info ("hda-intel" describes 1000s of slightly different devices).

0000:00:1b.0 0403: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 02)
Subsystem: Hewlett-Packard Company: Unknown device 30a0
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0, Cache Line Size: 0x10 (64 bytes)
Interrupt: pin A routed to IRQ 50
Region 0: Memory at d8240000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=55mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [60] Message Signalled Interrupts: 64bit+ Queue=0/0 Enable-
Address: 0000000000000000 Data: 0000
Capabilities: [70] #10 [0091]

Pretty much, I almost only know it is Conexant.

Quoted 2 lines

Does it work with the latest ALSA CVS or 1.0.11-rc4?

I don't know. It was working with 2.6.15-X

.Alejandro

Quoted 2 lines

Lee

#3 lore raw
Quoted 3 lines · Alejandro Bonilla
Quoted 1 line

Does it work with the latest ALSA CVS or 1.0.11-rc4?

I don't know. It was working with 2.6.15-X

Please test ALSA CVS or 1.0.11-rc4.

Lee

#4 lore raw
In reply to Alejandro Bonilla
Quoted 4 lines · Alejandro Bonilla
Quoted 1 line

Does it work with the latest ALSA CVS or 1.0.11-rc4?

I don't know. It was working with 2.6.15-X

Disregard last message, it's probably easiest to test the [ALSA PATCH] that was just posted.

Lee

#5 lore raw

On Fri, 31 Mar 2006 12:07:12 -0500, Lee Revell wrote

Quoted 8 lines · Alejandro Bonilla
Quoted 4 lines
Quoted 1 line

Does it work with the latest ALSA CVS or 1.0.11-rc4?

I don't know. It was working with 2.6.15-X

Disregard last message, it's probably easiest to test the [ALSA PATCH] that was just posted.

I will git fetch soon and see if it got merged and test that out.

Thanks,

.Alejandro

Quoted 2 lines

Lee

#6 lore raw
In reply to Alejandro Bonilla

At Fri, 31 Mar 2006 10:49:19 -0600,

Quoted 5 lines · Alejandro Bonilla

On Fri, 31 Mar 2006 11:40:58 -0500, Lee Revell wrote

Quoted 3 lines · Alejandro Bonilla
Quoted 2 lines

Hi,

Quoted 7 lines
Quoted 5 lines
Quoted 3 lines

I read about a problem with snd_hda_intel latelly on 2.6.16. I was not having this on 2.6.15-19 but looks like it is "chip-monking"

Too cryptic. What exactly is the problem?

The sound is like at 1.2x. Just a little bit faster but noticeable.

Faster? You mean pitch or only playback speed?
It's the first report I've heard. Usually, the regression is either noisy output or silence...

Try position_fix=1, or a different value, if the latest ALSA version still doesn't work.

Quoted 27 lines
Quoted 8 lines
Quoted 5 lines

I use linux2.6 git and it is still present. Just wanted to let you'll know about it.

Should anyone need any info, please let me know.

Well, for starters, your hardware info ("hda-intel" describes 1000s of slightly different devices).

0000:00:1b.0 0403: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 02)
Subsystem: Hewlett-Packard Company: Unknown device 30a0
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0, Cache Line Size: 0x10 (64 bytes)
Interrupt: pin A routed to IRQ 50
Region 0: Memory at d8240000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=55mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [60] Message Signalled Interrupts: 64bit+ Queue=0/0 Enable-
Address: 0000000000000000 Data: 0000
Capabilities: [70] #10 [0091]

Quoted 1 line

Pretty much, I almost only know it is Conexant.

Better check /proc/asound/card0/codec#* files.

Sigh, Conexant. It's a problematic one. They don't give any technical information.

Quoted 4 lines
Quoted 2 lines

Does it work with the latest ALSA CVS or 1.0.11-rc4?

I don't know. It was working with 2.6.15-X

Any other changes on your system except for kernel?

Takashi

#7 lore raw

On Fri, 31 Mar 2006 19:47:43 +0200, Takashi Iwai wrote

Quoted 8 lines

At Fri, 31 Mar 2006 10:49:19 -0600,

Quoted 6 lines · Alejandro Bonilla

On Fri, 31 Mar 2006 11:40:58 -0500, Lee Revell wrote

Quoted 4 lines · Alejandro Bonilla
Quoted 3 lines

Hi,

I read about a problem with snd_hda_intel latelly on 2.6.16. I was not

having

Quoted 8 lines
Quoted 6 lines
Quoted 4 lines
Quoted 2 lines

this on 2.6.15-19 but looks like it is "chip-monking"

Too cryptic. What exactly is the problem?

The sound is like at 1.2x. Just a little bit faster but noticeable.

Faster? You mean pitch or only playback speed?

Yes, it is just a bit faster. In speed.

Quoted 5 lines

It's the first report I've heard. Usually, the regression is either noisy output or silence...

Try position_fix=1, or a different value, if the latest ALSA version still doesn't work.

root@ubuntu:~# echo 1 > /sys/bus/pci/drivers/HDA\
Intel/module/parameters/position_fix
-bash: /sys/bus/pci/drivers/HDA Intel/module/parameters/position_fix:
Permission denied

It might take me awhile to unload all the modules and try loading it again. :) I'll get back to you.

and

I will try the new patch when gets merged.

Quoted 10 lines
Quoted 10 lines
Quoted 9 lines
Quoted 6 lines

I use linux2.6 git and it is still present. Just wanted to let you'll know about it.

Should anyone need any info, please let me know.

Well, for starters, your hardware info ("hda-intel" describes 1000s of slightly different devices).

Quoted 15 lines
Quoted 7 lines

0000:00:1b.0 0403: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 02)
Subsystem: Hewlett-Packard Company: Unknown device 30a0
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR-

Quoted 8 lines

Latency: 0, Cache Line Size: 0x10 (64 bytes)
Interrupt: pin A routed to IRQ 50
Region 0: Memory at d8240000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=55mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [60] Message Signalled Interrupts: 64bit+ Queue=0/0

Enable-

Quoted 6 lines
Quoted 4 lines
                Address: 0000000000000000  Data: 0000
        Capabilities: [70] #10 [0091]

Pretty much, I almost only know it is Conexant.

Better check /proc/asound/card0/codec#* files.

The file is too big, any hint of what you might want to look at?

Quoted 3 lines

Sigh, Conexant. It's a problematic one. They don't give any technical information.

:|

Quoted 7 lines
Quoted 5 lines
Quoted 3 lines

Does it work with the latest ALSA CVS or 1.0.11-rc4?

I don't know. It was working with 2.6.15-X

Any other changes on your system except for kernel?

No, if I boot back to 2.6.15-19 it works.

Quoted 2 lines

Takashi

--
Open WebMail Project (http://openwebmail.org)