2.6.17-rc1: SCSI kobject_add problems
System is a DEC Alpha 433au with two SCSI disks. SCSI controller is a QLA1040 supported by the qla1280 driver. Runs 2.6.16 fine. Tried booting 2.6.17-rc1 and got
kobject_add failed for 0:0: with -EEXIST, don't try to register things with the same name in the same directory
and a fairly long trace output when the system attempted to add sdb. Not surprisingly, sdb was inaccessible.
Normally (for 2.6.16 anyway), the following relationship exists:
sd 0:0:0:0 sda
sd 0:0:1:0 sdb
More information *might* be available if needed, but will have to be transcribed by hand. My /usr partition is on sdb, so I don't get very far with 2.6.17-rc1 on Alpha :-). The problem is probably specific to the qla1280 or the Alpha, as I have a x86 Adaptec SCSI-based system with multiple spindles that works fine with 2.6.17-rc1.
Signature · 4 lines
----------------------------------------------------------------------- Bob Tracy WTO + WIPO = DMCA? http://www.anti-dmca.org [email protected] -----------------------------------------------------------------------