serial interface in U-boot
Hi all,
I am successfully able to configure the u-boot for phytec board (for ARM7TDMI). I am getting the u-boot prompt.
But the problem is i am not able to trnasfer the image at specified address in RAM( which is say 0x81000000). Even u-boot is finding this address , thts not the issue.
I am transferring a sample application code (blink LED) at this location. As i am getting the prompt and other prints through minicom utility , serial interface is working.
Is there any configurable option need to set say for ymodem, kermit,xmodem,zmodem in u-boot ? so that i can transfer my application image through minicom.
In my board_config.h file i have define : CONFIG_BAUDRATE 9600
but when i execute the 'bdinfo' command from the prompt i am getting baud as 0.
Can anyone please let me know about this.
Thanks and Regards,
Kaushik
---------------------------------
Love cheap thrills? Enjoy PC-to-Phone calls to 30+ countries for just 2?/min with Yahoo! Messenger with Voice. -------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20060510/52e4d956/attachment.htm
Quoted 2 lines
Quoted 2 lines
In my
board_config.hfile i have define :CONFIG_BAUDRATE9600 but when i execute the 'bdinfo' command from the prompt i am
getting baud as 0.
It may be the problem with your u-boot configuration. I also the got the same problem once. We can say number of reasons. Are you getting any warnings like 'bad CRC using defaults environment'? Are you sure that your u-boot configuration is properly configured for flash address and length/size settings?
Thanks & Regards,
P. Ganesh Ramachandran.