uboot for TI DSP c6000
Quoted 36 lines · --- paul burrell
Frank,
What am I missing here? Sounds like you have some
experience, so could you
answer a couple of questions.First I should clarify a couple of things just in case I did not communicate
them correctly.The target is a TI TMS320C6204. It is a DSP from TI using a
C64 core. It
is not one of the OMAPs with an embedded ARM. The normal GCC
compiler set
does not appear to support the C6000 process, but I just found some
documentation indicating that might not be true.1. So I went to the ELDK page (DENX). According to the
page, it only
supports PowerPC. I am going to download it and check, but that is all I
see. I did see that they have ARM, PPC, and MIPS directories, so it might
be more than PPC.
2. So lets say it does support it, what toolchain should I be looking at?
Version numbers would be nice.In the end, embedded linix is going to be more than what I
need. I am just
trying to have a simple bootloader with the ability to edit memory, test
functions, program flash, and load over a serial port. I don't even need
networking capability.
Quoted 4 lines
Any advice would be great.
Thanks,
Paul
No, I missed something. I assumed you were working on the DM6446 with an ARM core and DSP and wanted to boot the board with the ARM. if that's not the case, then I am off base...
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com