Dynamic kernel command-line - sh
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 6 lines · Alon Bar-Lev
1. Rename
saved_command_lineintoboot_command_line.
2. Setcommand_lineas__initdata.Signed-off-by Alon Bar-Lev <[email protected]>
The sh bits look fine, though I'm fairly impartial to this change. It doesn't seem like this is going to be needed in very many places..
In the future, you may also wish to CC linux-arch if you want the attention of architecture maintainers.
Quoted 6 lines · Alon Bar-Lev
1. Rename
saved_command_lineintoboot_command_line.
2. Setcommand_lineas__initdata.Signed-off-by Alon Bar-Lev <[email protected]>
Likewise for sh64.
Quoted 2 lines · Paul Mundt
The sh bits look fine, though I'm fairly impartial to this change. It doesn't seem like this is going to be needed in very many places..
Thank you for your quick response!
But I failed to push i386 command-line size to more than 256 bytes... You are right, it is required only for memory extreme devices...
Options:
1. Add COMMAND_LINE_SIZE to kernel config - was rejected because kernel has already too much parameters, this was the initial patch more than a year ago.
2. Just increase COMMAND_LINE_SIZE of i386, x86_64 - was rejected because of it affecting low memory devices.
3. Convert the command-line into dynamically allocated buffers - this try.
Quoted 2 lines
In the future, you may also wish to CC linux-arch if you want the attention of architecture maintainers.
Thank you, I was not aware of this.
I hope there will be no take 3 :)
Best Regards,
Alon Bar-Lev.