Skip to contentSkip to conversation

Hermes PCI broken on 2.6.20?

DISCUSSION Deepak Saxena 2 participants 2 messages Feb 9, 2007

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

Running both 2.6.20 and 2.6.18, the hermes PCI driver (CONFIG_HERMES_PCI) gives the following errors. Card is a revision 1 chipset (Dev ID 3873). Note that when iwconfig is run a few times in a row, the error messages go away but they might just be getting ratelimited. Anyone else seen this?

[email protected]:~# iwconfig
eth0      no wirhermes @ c8810000: Card removed while waiting for command
0x0021 completion.
eless extensionshermes @ c8810000: Card removed while issuing command
0x0021.
.

lo nhermes @ c8810000: Card removed while issuing command 0x0021.
o wireless extenhermes @ c8810000: Card removed while issuing command 0x0021.
sions.

eth1 hermes @ c8810000: Card removed while issuing command 0x0021.
no wireless hermes @ c8810000: Card removed while issuing command
0x0011.
hermes @ c8810000: Card removed while issuing command 0x0021. extensions.

hermes @ c8810000: Card removed while issuing command 0x0021. hermes @ c8810000: Card removed while issuing command 0x0021.
eth2 IEEE 802.11-DS ESSID:"" Nickname:"Prism I"
Mode:Managed Bit Rate:11 Mb/s
RTS thr:off
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 invalid crypt:0 invalid misc:0

tunl0 no wireless extensions.

sit0 no wireless extensions.

ip6tnl0 no wireless extensions.

[email protected]:~# iwconfig eth2 essid qafarm-ap 
hermes @ c8810000: Card removed while issuing command 0x0011.
hermes @ c8810000: Card removed while issuing command 0x0021.
[email protected]:~# iwconfig eth2 essid qafarm-ap
printk: 3 messages suppressed.
hermes @ c8810000: Card removed while issuing command 0x0011.
[email protected]:~# iwconfig eth2 essid qafarm-ap
[email protected]:~# ifconfig eth2 10.40.20.200 netmask  255.255.252.0 up
hermes @ c8810000: BAP0 offset timeout: reg=0x8000 id=0xfc01 offset=0x0
eth2: Error -110 setting MAC address
eth2: Error -110 configuring card
SIOCSIFFLAGS: Coeth2: Error -110 setting MAC address
eth2: Error -110 configuring card
nnection timed out
SIOCSIFFLAGS: Connection timed out
Signature · 4 lines
Deepak Saxena - [email protected] - http://www.plexity.net

The terrorist and the policeman both come from the same basket.
	-- Joseph Conrad, The Secret Agent 
#1 lore raw

Hello!

Quoted 11 lines · Deepak Saxena

Running both 2.6.20 and 2.6.18, the hermes PCI driver (CONFIG_HERMES_PCI) gives the following errors. Card is a revision 1 chipset (Dev ID 3873). Note that when iwconfig is run a few times in a row, the error messages go away but they might just be getting ratelimited. Anyone else seen this?

[email protected]:~# iwconfig
eth0      no wirhermes @ c8810000: Card removed while waiting for command
0x0021 completion.
eless extensionshermes @ c8810000: Card removed while issuing command
0x0021.

I don't see any problems with orinoco_pci in Linux 2.6.20. It looks more like a hardware problem or some very old firmware.

Just to exclude possible problems with the driver that I cannot reproduce, please try hostap_pci. It supports all devices supported by orinoco_pci.

You may want to send further replies to [email protected] where it would be seen by those actually using the driver.

Signature · 2 lines
Regards,
Pavel Roskin