Hermes PCI broken on 2.6.20?
Subsystems (2)
Running both 2.6.20 and 2.6.18, the hermes PCI driver (CONFIG_HERMES_PCI) gives the following errors. Card is a revision 1 chipset (Dev ID 3873). Note that when iwconfig is run a few times in a row, the error messages go away but they might just be getting ratelimited. Anyone else seen this?
[email protected]:~# iwconfig eth0 no wirhermes @ c8810000: Card removed while waiting for command 0x0021 completion. eless extensionshermes @ c8810000: Card removed while issuing command 0x0021. .
lo nhermes @ c8810000: Card removed while issuing command 0x0021.
o wireless extenhermes @ c8810000: Card removed while issuing command 0x0021.
sions.
eth1 hermes @ c8810000: Card removed while issuing command 0x0021.
no wireless hermes @ c8810000: Card removed while issuing command0x0011.
hermes @ c8810000: Card removed while issuing command 0x0021. extensions.
hermes @ c8810000: Card removed while issuing command 0x0021. hermes @ c8810000: Card removed while issuing command 0x0021.
eth2 IEEE 802.11-DS ESSID:"" Nickname:"Prism I"
Mode:Managed Bit Rate:11 Mb/s
RTS thr:off
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0 Rx invalid nwid:0 invalid crypt:0 invalid misc:0
tunl0 no wireless extensions.
sit0 no wireless extensions.
ip6tnl0 no wireless extensions.
[email protected]:~# iwconfig eth2 essid qafarm-ap hermes @ c8810000: Card removed while issuing command 0x0011. hermes @ c8810000: Card removed while issuing command 0x0021. [email protected]:~# iwconfig eth2 essid qafarm-ap printk: 3 messages suppressed. hermes @ c8810000: Card removed while issuing command 0x0011. [email protected]:~# iwconfig eth2 essid qafarm-ap [email protected]:~# ifconfig eth2 10.40.20.200 netmask 255.255.252.0 up hermes @ c8810000: BAP0 offset timeout: reg=0x8000 id=0xfc01 offset=0x0 eth2: Error -110 setting MAC address eth2: Error -110 configuring card SIOCSIFFLAGS: Coeth2: Error -110 setting MAC address eth2: Error -110 configuring card nnection timed out SIOCSIFFLAGS: Connection timed out
Signature · 4 lines
Deepak Saxena - [email protected] - http://www.plexity.net The terrorist and the policeman both come from the same basket. -- Joseph Conrad, The Secret Agent
Hello!
Quoted 11 lines · Deepak Saxena
Running both 2.6.20 and 2.6.18, the hermes PCI driver (
CONFIG_HERMES_PCI) gives the following errors. Card is a revision 1 chipset (Dev ID 3873). Note that when iwconfig is run a few times in a row, the error messages go away but they might just be getting ratelimited. Anyone else seen this?[email protected]:~# iwconfig eth0 no wirhermes @ c8810000: Card removed while waiting for command 0x0021 completion. eless extensionshermes @ c8810000: Card removed while issuing command 0x0021.
I don't see any problems with orinoco_pci in Linux 2.6.20. It looks more like a hardware problem or some very old firmware.
Just to exclude possible problems with the driver that I cannot reproduce, please try hostap_pci. It supports all devices supported by orinoco_pci.
You may want to send further replies to [email protected] where it would be seen by those actually using the driver.
Signature · 2 lines
Regards, Pavel Roskin