Skip to contentSkip to conversation

Terratec Cinergy T USB XXS: remote does not work with 1.20 firmware

linux-dvb Nicolas George 2 participants 2 messages Feb 20, 2009 Media (V4L/DVB)

lore
Share & tools
lore
#0 lore raw

Hi.

I am trying to get the remote controller with a Terratec Cinergy T USB XXS. With the firmware dvb-usb-dib0700-1.10.fw, the remote sends codes (not perfectly, but I can see where I am going).

On the other hand, with dvb-usb-dib0700-1.20.fw, the remote does not detect anything. After some tracking, I found that in dib0700_rc_query_v1_20 (from dib0700_devices.c), the status from usb_bulk_msg is always -110 (-ETIMEDOUT).

Is there some way I can help fixing things? I do not mind using the old firmware, but I would like to help improving things.

Regards,

Signature · 1 line
  Nicolas George

_______________________________________________
linux-dvb users mailing list
For V4L/DVB development, please use instead [email protected] [email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

#1 lore raw
Quoted 6 lines · Nicolas George

Hi.

I am trying to get the remote controller with a Terratec Cinergy T USB XXS. With the firmware dvb-usb-dib0700-1.10.fw, the remote sends codes (not perfectly, but I can see where I am going).

Quoted 7 lines

On the other hand, with dvb-usb-dib0700-1.20.fw, the remote does not detect anything. After some tracking, I found that in dib0700_rc_query_v1_20 (from dib0700_devices.c), the status from usb_bulk_msg is always -110 (-ETIMEDOUT).

Is there some way I can help fixing things? I do not mind using the old firmware, but I would like to help improving things.

That's code I wrote, based on information provided by Patrick over at Dibcom.

I would have to look at the code, but if I recall, the code is designed to return -ETIMEDOUT during normal operation when no key press is detected. That said, seeing that return condition should not be perceived as a problem.

Are there any cases where it returns something *other* than -ETIMEDOUT? Because if so, then the keypress is probably being received but not processed properly.

I would recommend you add a line of code to printk() any return condition other than -ETIMEDOUT, and see if something shows up in the log when you try to use the remote control.

Devin

Signature · 3 lines
Devin J. Heitmueller
http://www.devinheitmueller.com
AIM: devinheitmueller