Skip to contentSkip to conversation

MFD: add support for the RDC321x southbridge

PATCH In review Florian Fainelli 1 participant 1 message Mar 21, 2010 Multifunction devices (MFD)

lore
Share & tools
lore
#0 lore raw

PATCH v3 1/4 MFD: add support for the RDC321x southbridge

This patch adds a new MFD driver for the RDC321x southbridge. This southbridge is always present in the RDC321x System-on-a-Chip and provides access to some GPIOs as well as a watchdog. Access to these two functions is done using the southbridge PCI device configuration space.

---
Changes from v2:
- pass the pci_dev pointer to MFD cell drivers as platform_data
- remove the printk(KERN_ERR and use dev_err instead
- removed pci_dev accessors
- use DEFINE_PCI_DEVICE_TABLE

drivers/mfd/Kconfig +9 -0
index 951fa9b..8cc8218 100644
@@ -398,6 +398,15 @@ config LPC_SCH
 	  LPC bridge function of the Intel SCH provides support for
 	  System Management Bus and General Purpose I/O.
 
+config MFD_RDC321X
+	tristate "Support for RDC-R321x southbridge"
+	select MFD_CORE
+	depends on PCI
+	help
+	  Say yes here if you want to have support for the RDC R-321x SoC
+	  southbridge which provides access to GPIOs and Watchdog using the
+	  southbridge PCI device configuration space.
+
 endmenu
 
 menu "Multimedia Capabilities Port drivers"
drivers/mfd/Makefile +2 -1
index 22715ad..f5daffe 100644
@@ -62,4 +62,5 @@ obj-$(CONFIG_AB3100_OTP)	+= ab3100-otp.o
 obj-$(CONFIG_AB4500_CORE)	+= ab4500-core.o
 obj-$(CONFIG_MFD_TIMBERDALE)    += timberdale.o
 obj-$(CONFIG_PMIC_ADP5520)	+= adp5520.o
-obj-$(CONFIG_LPC_SCH)		+= lpc_sch.o
\ No newline at end of file
+obj-$(CONFIG_LPC_SCH)		+= lpc_sch.o
+obj-$(CONFIG_MFD_RDC321X)	+= rdc321x-southbridge.o
drivers/mfd/rdc321x-southbridge.c new file +123 -0

123 lines not on this page · raw message

include/linux/mfd/rdc321x.h new file +26 -0
new file mode 100644
index 0000000..4bdf19c
@@ -0,0 +1,26 @@
+#ifndef __RDC321X_MFD_H
+#define __RDC321X_MFD_H
+
+#include <linux/types.h>
+#include <linux/pci.h>
+
+/* Offsets to be accessed in the southbridge PCI
+ * device configuration register */
+#define RDC321X_WDT_CTRL	0x44
+#define RDC321X_GPIO_CTRL_REG1	0x48
+#define RDC321X_GPIO_DATA_REG1	0x4c
+#define RDC321X_GPIO_CTRL_REG2	0x84
+#define RDC321X_GPIO_DATA_REG2	0x88
+
+#define RDC321X_MAX_GPIO	58
+
+struct rdc321x_gpio_pdata {
+	struct pci_dev *sb_pdev;
+	unsigned max_gpios;
+};
+
+struct rdc321x_wdt_pdata {
+	struct pci_dev *sb_pdev;
+};
+
+#endif /* __RDC321X_MFD_H */