Skip to contentSkip to conversation

mpt2sas : When SCSI command is received with task atrribute not set, set it to SIMPLE

PATCH RESEND In review Sreekanth Reddy 1 participant 1 message Feb 1, 2013 SCSI

lore
Share & tools
lore
#0 lore raw

PATCH RESEND 6/8 mpt2sas : When SCSI command is received with task atrribute not set, set it to SIMPLE

When SCSI command is received with task attribute not set, set it to SIMPLE. Previously it is set to untagged. This causes the firmware to fail the commands.

---

drivers/scsi/mpt2sas/mpt2sas_scsih.c +1 -5
index 014caef..3b150b8 100644
@@ -3998,11 +3998,7 @@ _scsih_qcmd_lck(struct scsi_cmnd *scmd, void (*done)(struct scsi_cmnd *))
 			else
 				mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
 		} else
-/* MPI Revision I (UNIT = 0xA) - removed MPI2_SCSIIO_CONTROL_UNTAGGED */
-/*			mpi_control |= MPI2_SCSIIO_CONTROL_UNTAGGED;
- */
-			mpi_control |= (0x500);
-
+			mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
 	} else
 		mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
 	/* Make sure Device is not raid volume.