mpt2sas : When SCSI command is received with task atrribute not set, set it to SIMPLE
PATCH RESEND 6/8 mpt2sas : When SCSI command is received with task atrribute not set, set it to SIMPLE
When SCSI command is received with task attribute not set, set it to SIMPLE. Previously it is set to untagged. This causes the firmware to fail the commands.
Signed-off-by Sreekanth Reddy <[email protected]>
---
drivers/scsi/mpt2sas/mpt2sas_scsih.c +1 -5
@@ -3998,11 +3998,7 @@ _scsih_qcmd_lck(struct scsi_cmnd *scmd, void (*done)(struct scsi_cmnd *))else mpi_control |=MPI2_SCSIIO_CONTROL_SIMPLEQ ; }else -/* MPI Revision I (UNIT = 0xA) - removed MPI2_SCSIIO_CONTROL_UNTAGGED */ -/* mpi_control |= MPI2_SCSIIO_CONTROL_UNTAGGED; -*/ - mpi_control |= (0x500 ); - + mpi_control |=MPI2_SCSIIO_CONTROL_SIMPLEQ ; }else mpi_control |=MPI2_SCSIIO_CONTROL_SIMPLEQ ;/* Make sure Device is not raid volume.