ARM: dts: aspeed: Fix SCU IRQ controller node addresses

Warnings were introduced due to unit address on nodes that had no reg property. Drop the unit addresses from the nodes.

Eddie James (2):
ARM: dts: aspeed: ast2500: Fix SCU IRQ controller node address
ARM: dts: aspeed: ast2600: Fix SCU IRQ controller node addresses

 arch/arm/boot/dts/aspeed-g5.dtsi | 2 +-
 arch/arm/boot/dts/aspeed-g6.dtsi | 4 ++--
 2 files changed, 3 insertions(+), 3 deletions(-)

2.24.0

The node was defined with a unit address but had no reg property, resulting in a warning. The address is unecessary, so drop it.

---
 arch/arm/boot/dts/aspeed-g5.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

index 569f9d74c696..aeee18fc1e7e 100644
@@ -222,7 +222,7 @@ syscon: syscon at 1e6e2000 {
 				#clock-cells = <1>;
 				#reset-cells = <1>;
 
-				scu_ic: interrupt-controller at 18 {
+				scu_ic: interrupt-controller {
 					#interrupt-cells = <1>;
 					compatible = "aspeed,ast2500-scu-ic";
 					interrupts = <21>;

2.24.0

Please add a reg property instead of removing the unit address.

The hardware still lives at that address, even if your driver doesn't currently use that information.

Cheers,

Joel

The nodes were defined with a unit address but had no reg property, resulting in a warning. The address is unecessary, so drop it.

---
 arch/arm/boot/dts/aspeed-g6.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

index 82a3cd10cc2b..6f6a2d0217dc 100644
@@ -269,14 +269,14 @@ smp-memram at 180 {
 					reg = <0x180 0x40>;
 				};
 
-				scu_ic0: interrupt-controller at 0 {
+				scu_ic0: interrupt-controller {
 					#interrupt-cells = <1>;
 					compatible = "aspeed,ast2600-scu-ic0";
 					interrupts = <GIC_SPI 12 IRQ_TYPE_LEVEL_HIGH>;
 					interrupt-controller;
 				};
 
-				scu_ic1: interrupt-controller at 1 {
+				scu_ic1: interrupt-controller {
 					#interrupt-cells = <1>;
 					compatible = "aspeed,ast2600-scu-ic1";
 					interrupts = <GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH>;

2.24.0