dt-bindings: media: imx7 and ov2680 updates to yaml

deleted file mode 100644
index 11e925ed9dad..000000000000
@@ -1,46 +0,0 @@
-* Omnivision OV2680 MIPI CSI-2 sensor
-
-Required Properties:
-- compatible: should be "ovti,ov2680".
-- clocks: reference to the xvclk input clock.
-- clock-names: should be "xvclk".
-- DOVDD-supply: Digital I/O voltage supply.
-- DVDD-supply: Digital core voltage supply.
-- AVDD-supply: Analog voltage supply.
-
-Optional Properties:
-- reset-gpios: reference to the GPIO connected to the powerdown/reset pin,
-               if any. This is an active low signal to the OV2680.
-
-The device node must contain one 'port' child node for its digital output
-video port, and this port must have a single endpoint in accordance with
- the video interface bindings defined in
-Documentation/devicetree/bindings/media/video-interfaces.txt.
-
-Endpoint node required properties for CSI-2 connection are:
-- remote-endpoint: a phandle to the bus receiver's endpoint node.
-- clock-lanes: should be set to <0> (clock lane on hardware lane 0).
-- data-lanes: should be set to <1> (one CSI-2 lane supported).
-
-Example:
-
-&i2c2 {
-	ov2680: camera-sensor@36 {
-		compatible = "ovti,ov2680";
-		reg = <0x36>;
-		clocks = <&osc>;
-		clock-names = "xvclk";
-		reset-gpios = <&gpio1 3 GPIO_ACTIVE_LOW>;
-		DOVDD-supply = <&sw2_reg>;
-		DVDD-supply = <&sw2_reg>;
-		AVDD-supply = <&reg_peri_3p15v>;
-
-		port {
-			ov2680_to_mipi: endpoint {
-				remote-endpoint = <&mipi_from_sensor>;
-				clock-lanes = <0>;
-				data-lanes = <1>;
-			};
-		};
-	};
-};

131 lines not on this page · raw message

index 2e85e114c9c3..926dcdc4794c 100644
@@ -12775,7 +12775,7 @@ M:	Rui Miguel Silva <[email protected]>
 L:	[email protected]
 S:	Maintained
 T:	git git://linuxtv.org/media_tree.git
-F:	Documentation/devicetree/bindings/media/i2c/ov2680.txt
+F:	Documentation/devicetree/bindings/media/i2c/ov2680.yaml
 F:	drivers/media/i2c/ov2680.c
 
 OMNIVISION OV2685 SENSOR DRIVER

deleted file mode 100644
index d80ceefa0c00..000000000000
@@ -1,42 +0,0 @@
-Freescale i.MX7 CMOS Sensor Interface
-=====================================
-
-csi node
---------
-
-This is device node for the CMOS Sensor Interface (CSI) which enables the chip
-to connect directly to external CMOS image sensors.
-
-Required properties:
-
-- compatible    : "fsl,imx7-csi" or "fsl,imx6ul-csi";
-- reg           : base address and length of the register set for the device;
-- interrupts    : should contain CSI interrupt;
-- clocks        : list of clock specifiers, see
-        Documentation/devicetree/bindings/clock/clock-bindings.txt for details;
-- clock-names   : must contain "mclk";
-
-The device node shall contain one 'port' child node with one child 'endpoint'
-node, according to the bindings defined in:
-Documentation/devicetree/bindings/media/video-interfaces.txt.
-
-In the following example a remote endpoint is a video multiplexer.
-
-example:
-
-                csi: csi@30710000 {
-                        #address-cells = <1>;
-                        #size-cells = <0>;
-
-                        compatible = "fsl,imx7-csi";
-                        reg = <0x30710000 0x10000>;
-                        interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>;
-                        clocks = <&clks IMX7D_CSI_MCLK_ROOT_CLK>;
-                        clock-names = "mclk";
-
-                        port {
-                                csi_from_csi_mux: endpoint {
-                                        remote-endpoint = <&csi_mux_to_csi>;
-                                };
-                        };
-                };

84 lines not on this page · raw message

index 926dcdc4794c..b7f7f14cd85b 100644
@@ -10773,8 +10773,8 @@ L:	[email protected]
 S:	Maintained
 T:	git git://linuxtv.org/media_tree.git
 F:	Documentation/admin-guide/media/imx7.rst
-F:	Documentation/devicetree/bindings/media/imx7-csi.txt
 F:	Documentation/devicetree/bindings/media/imx7-mipi-csi2.txt
+F:	Documentation/devicetree/bindings/media/nxp,imx7-csi.yaml
 F:	drivers/staging/media/imx/imx7-media-csi.c
 F:	drivers/staging/media/imx/imx7-mipi-csis.c
 

deleted file mode 100644
index 71fd74ed3ec8..000000000000
@@ -1,90 +0,0 @@
-Freescale i.MX7 Mipi CSI2
-=========================
-
-mipi_csi2 node
---------------
-
-This is the device node for the MIPI CSI-2 receiver core in i.MX7 SoC. It is
-compatible with previous version of Samsung D-phy.
-
-Required properties:
-
-- compatible    : "fsl,imx7-mipi-csi2";
-- reg           : base address and length of the register set for the device;
-- interrupts    : should contain MIPI CSIS interrupt;
-- clocks        : list of clock specifiers, see
-        Documentation/devicetree/bindings/clock/clock-bindings.txt for details;
-- clock-names   : must contain "pclk", "wrap" and "phy" entries, matching
-                  entries in the clock property;
-- power-domains : a phandle to the power domain, see
-          Documentation/devicetree/bindings/power/power_domain.txt for details.
-- reset-names   : should include following entry "mrst";
-- resets        : a list of phandle, should contain reset entry of
-                  reset-names;
-- phy-supply    : from the generic phy bindings, a phandle to a regulator that
-	          provides power to MIPI CSIS core;
-
-Optional properties:
-
-- clock-frequency : The IP's main (system bus) clock frequency in Hz, default
-		    value when this property is not specified is 166 MHz;
-- fsl,csis-hs-settle : differential receiver (HS-RX) settle time;
-
-The device node should contain two 'port' child nodes with one child 'endpoint'
-node, according to the bindings defined in:
- Documentation/devicetree/bindings/ media/video-interfaces.txt.
- The following are properties specific to those nodes.
-
-port node
----------
-
-- reg		  : (required) can take the values 0 or 1, where 0 shall be
-                     related to the sink port and port 1 shall be the source
-                     one;
-
-endpoint node
--------------
-
-- data-lanes    : (required) an array specifying active physical MIPI-CSI2
-		    data input lanes and their mapping to logical lanes; this
-                    shall only be applied to port 0 (sink port), the array's
-                    content is unused only its length is meaningful,
-                    in this case the maximum length supported is 2;
-
-example:
-
-        mipi_csi: mipi-csi@30750000 {
-                #address-cells = <1>;
-                #size-cells = <0>;
-
-                compatible = "fsl,imx7-mipi-csi2";
-                reg = <0x30750000 0x10000>;
-                interrupts = <GIC_SPI 25 IRQ_TYPE_LEVEL_HIGH>;
-                clocks = <&clks IMX7D_IPG_ROOT_CLK>,
-                                <&clks IMX7D_MIPI_CSI_ROOT_CLK>,
-                                <&clks IMX7D_MIPI_DPHY_ROOT_CLK>;
-                clock-names = "pclk", "wrap", "phy";
-                clock-frequency = <166000000>;
-                power-domains = <&pgc_mipi_phy>;
-                phy-supply = <&reg_1p0d>;
-                resets = <&src IMX7_RESET_MIPI_PHY_MRST>;
-                reset-names = "mrst";
-                fsl,csis-hs-settle = <3>;
-
-                port@0 {
-                        reg = <0>;
-
-                        mipi_from_sensor: endpoint {
-                                remote-endpoint = <&ov2680_to_mipi>;
-                                data-lanes = <1>;
-                        };
-                };
-
-                port@1 {
-                        reg = <1>;
-
-                        mipi_vc0_to_csi_mux: endpoint {
-                                remote-endpoint = <&csi_mux_from_mipi_vc0>;
-                        };
-                };
-        };

181 lines not on this page · raw message

index b7f7f14cd85b..9da67222b0c7 100644
@@ -10773,8 +10773,8 @@ L:	[email protected]
 S:	Maintained
 T:	git git://linuxtv.org/media_tree.git
 F:	Documentation/admin-guide/media/imx7.rst
-F:	Documentation/devicetree/bindings/media/imx7-mipi-csi2.txt
 F:	Documentation/devicetree/bindings/media/nxp,imx7-csi.yaml
+F:	Documentation/devicetree/bindings/media/nxp,imx7-mipi-csi2.yaml
 F:	drivers/staging/media/imx/imx7-media-csi.c
 F:	drivers/staging/media/imx/imx7-mipi-csis.c