rng: npcm: add Arbel NPCM8XX support
Subsystems (4)
Tomer Maimon
maintainercover rng: npcm: add Arbel NPCM8XX support
This patch set adds Arbel NPCM8XX Random Number Generator(RNG) support to RNG NPCM driver.
The NPCM8XX RNG uses different prescalar clock value.
The NPCM RNG driver was tested on the NPCM845 evaluation board.
Tomer Maimon (2):
dt-bindings: rng: nuvoton,npcm-rng: Add npcm845 compatible string
hwrng: npcm: Add NPCM8XX support
.../bindings/rng/nuvoton,npcm-rng.yaml | 4 +++- drivers/char/hw_random/npcm-rng.c | 21 ++++++++++++------- 2 files changed, 17 insertions(+), 8 deletions(-)
Signature · 1 line
2.33.0
Tomer Maimon
maintainerPATCH 1/2 dt-bindings: rng: nuvoton,npcm-rng: Add npcm845 compatible string
Add a compatible string for Nuvoton BMC NPCM845 RNG.
--- Documentation/devicetree/bindings/rng/nuvoton,npcm-rng.yaml | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
Documentation/devicetree/bindings/rng/nuvoton,npcm-rng.yaml +3 -1
@@ -16,7 +16,9 @@ maintainers: properties: compatible: - const: nuvoton,npcm750-rng + enum: + - nuvoton,npcm750-rng + - nuvoton,npcm845-rng reg: maxItems: 1
Signature · 1 line
2.33.0
Re: [PATCH v1 1/2] dt-bindings: rng: nuvoton,npcm-rng: Add npcm845 compatible string
Quoted 5 lines · Tomer Maimon
Add a compatible string for Nuvoton BMC NPCM845 RNG.
Signed-off-by Tomer Maimon <[email protected]>--- Documentation/devicetree/bindings/rng/nuvoton,npcm-rng.yaml | 4 +++-
Best regards,
Krzysztof
Re: [PATCH v1 1/2] dt-bindings: rng: nuvoton,npcm-rng: Add npcm845 compatible string
Quoted 9 lines · Krzysztof Kozlowski
Quoted 5 lines · Tomer Maimon
Add a compatible string for Nuvoton BMC NPCM845 RNG.
Signed-off-by Tomer Maimon <[email protected]>--- Documentation/devicetree/bindings/rng/nuvoton,npcm-rng.yaml | 4 +++-
And un-acked. Test your patches.
Please run make dt_binding_check (see Documentation/devicetree/bindings/writing-schema.rst for instructions).
Best regards,
Krzysztof
Re: [PATCH v1 1/2] dt-bindings: rng: nuvoton,npcm-rng: Add npcm845 compatible string
In reply to Tomer MaimonQuoted 7 lines · Tomer Maimon
Add a compatible string for Nuvoton BMC NPCM845 RNG.
Signed-off-by Tomer Maimon <[email protected]>--- Documentation/devicetree/bindings/rng/nuvoton,npcm-rng.yaml | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13):
yamllint warnings/errors:./Documentation/devicetree/bindings/rng/nuvoton,npcm-rng.yaml:20:9: [warning] wrong indentation: expected 6 but found 8 (indentation)
dtschema/dtc warnings/errors:
doc reference errors (make refcheckdocs):
See https://patchwork.ozlabs.org/patch/1681163
This check can fail if there are any dependencies. The base for a patch series is generally the most recent rc1.
If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date:
pip3 install dtschema --upgrade
Please check and re-submit.
Tomer Maimon
maintainerPATCH 2/2 hwrng: npcm: Add NPCM8XX support
In reply to Tomer MaimonAdding RNG NPCM8XX support to NPCM RNG driver.
RNG NPCM8XX uses a different clock prescaler.
As part of adding NPCM8XX support:
- Add NPCM8XX specific compatible string.
- Add NPCM8XX specific clock prescaler.
--- drivers/char/hw_random/npcm-rng.c | 21 ++++++++++++++------- 1 file changed, 14 insertions(+), 7 deletions(-)
drivers/char/hw_random/npcm-rng.c +14 -7
@@ -18,10 +18,11 @@#define NPCM_RNGD_REG 0x04/* Data register */ #define NPCM_RNGMODE_REG 0x08/* Mode register */ -#define NPCM_RNG_CLK_SET_25MHZ GENMASK(4, 3)/* 20-25 MHz */ -#define NPCM_RNG_DATA_VALID BIT(1) -#define NPCM_RNG_ENABLE BIT(0) -#define NPCM_RNG_M1ROSEL BIT(1) +#define NPCM_RNG_CLK_SET_25MHZ GENMASK(4, 3)/* 20-25 MHz */ +#define NPCM_RNG_CLK_SET_62_5MHZ BIT(2)/* 60-80 MHz */ +#define NPCM_RNG_DATA_VALID BIT(1) +#define NPCM_RNG_ENABLE BIT(0) +#define NPCM_RNG_M1ROSEL BIT(1)#define NPCM_RNG_TIMEOUT_USEC 20000#define NPCM_RNG_POLL_USEC 1000
@@ -31,14 +32,14 @@struct npcm_rng {void __iomem *base;struct hwrng rng; +u32 clkp; };static int npcm_rng_init (struct hwrng *rng) {struct npcm_rng *priv =to_npcm_rng (rng); -writel (NPCM_RNG_CLK_SET_25MHZ |NPCM_RNG_ENABLE , - priv->base +NPCM_RNGCS_REG ); +writel (priv->clkp |NPCM_RNG_ENABLE , priv->base +NPCM_RNGCS_REG );return 0 ; }
@@ -47,7 +48,7 @@ static void npcm_rng_cleanup(struct hwrng *rng) {struct npcm_rng *priv =to_npcm_rng (rng); -writel (NPCM_RNG_CLK_SET_25MHZ , priv->base +NPCM_RNGCS_REG ); +writel (priv->clkp, priv->base +NPCM_RNGCS_REG ); }static int npcm_rng_read (struct hwrng *rng,void *buf,size_t max,bool wait)
@@ -102,6 +103,11 @@ static int npcm_rng_probe(struct platform_device *pdev)pm_runtime_use_autosuspend (&pdev->dev);pm_runtime_enable (&pdev->dev); +if (of_device_is_compatible (pdev->dev.of_node,"nuvoton,npcm750-rng" )) + priv->clkp =NPCM_RNG_CLK_SET_25MHZ ; +if (of_device_is_compatible (pdev->dev.of_node,"nuvoton,npcm845-rng" )) + priv->clkp =NPCM_RNG_CLK_SET_62_5MHZ ; +#ifndef CONFIG_PM priv->rng.init = npcm_rng_init; priv->rng.cleanup = npcm_rng_cleanup;
@@ -163,6 +169,7 @@ static const struct dev_pm_ops npcm_rng_pm_ops = {static const struct of_device_id rng_dt_id[]__maybe_unused = { { .compatible ="nuvoton,npcm750-rng" , }, + { .compatible ="nuvoton,npcm845-rng" , }, {}, };MODULE_DEVICE_TABLE (of, rng_dt_id);
Signature · 1 line
2.33.0
Re: [PATCH v1 2/2] hwrng: npcm: Add NPCM8XX support
drivers/char/hw_random/npcm-rng.c static int npcm_rng_probe(struct platform_device *pdev) · line 109
Quoted 9 lines · Tomer Maimon
static int
npcm_rng_read(struct hwrng *rng, void *buf, size_t max, bool wait)drivers/char/hw_random/npcm-rng.c +4
-0@@ -102,6 +103,11 @@ static int npcm_rng_probe(struct platform_device *pdev)pm_runtime_use_autosuspend (&pdev->dev);pm_runtime_enable (&pdev->dev); +if (of_device_is_compatible (pdev->dev.of_node,"nuvoton,npcm750-rng" )) + priv->clkp =NPCM_RNG_CLK_SET_25MHZ ; +if (of_device_is_compatible (pdev->dev.of_node,"nuvoton,npcm845-rng" )) + priv->clkp =NPCM_RNG_CLK_SET_62_5MHZ ;
No, don't sprinkle compatibles here and there. Driver data is for this.
Best regards,
Krzysztof