Skip to contentSkip to conversation

spi: soft_spi: Support the recommended soft spi properties

PATCH In review Fabio Estevam 2 participants 4 messages May 18, 2023 – Jun 11, 2023 SPI

lore
Share & tools
lore
#0 lore raw

PATCH 1/2 spi: soft_spi: Support the recommended soft spi properties

From: Fabio Estevam <[email protected]>

According to Documentation/devicetree/bindings/spi/spi-gpio.yaml from Linux, the recommended spio-gpio properties are:

sck-gpios, miso-gpios and mosi-gpios.

gpio-sck, gpio-mosi and gpio-miso are considered deprecated.

Currently, U-Boot only supports the deprecated properties.

Allow the soft_spi driver to support both the new and old properties.

---
 drivers/spi/soft_spi.c | 21 +++++++++++++++++----
 1 file changed, 17 insertions(+), 4 deletions(-)
drivers/spi/soft_spi.c +17 -4
index f3602a25ba30..0fa14339bdcd 100644
@@ -248,19 +248,32 @@ static int soft_spi_probe(struct udevice *dev)
 	cs_flags = (slave && slave->mode & SPI_CS_HIGH) ? 0 : GPIOD_ACTIVE_LOW;
 	clk_flags = (slave && slave->mode & SPI_CPOL) ? GPIOD_ACTIVE_LOW : 0;
 
-	if (gpio_request_by_name(dev, "cs-gpios", 0, &plat->cs,
-				 GPIOD_IS_OUT | cs_flags) ||
-	    gpio_request_by_name(dev, "gpio-sck", 0, &plat->sclk,
-				 GPIOD_IS_OUT | clk_flags))
+	ret = gpio_request_by_name(dev, "cs-gpios", 0, &plat->cs,
+				   GPIOD_IS_OUT | cs_flags);
+	if (ret)
+		return -EINVAL;
+
+	ret = gpio_request_by_name(dev, "gpio-sck", 0, &plat->sclk,
+				   GPIOD_IS_OUT | clk_flags);
+	if (ret)
+		ret = gpio_request_by_name(dev, "sck-gpios", 0, &plat->sclk,
+					   GPIOD_IS_OUT | clk_flags);
+	if (ret)
 		return -EINVAL;
 
 	ret = gpio_request_by_name(dev, "gpio-mosi", 0, &plat->mosi,
 				   GPIOD_IS_OUT | GPIOD_IS_OUT_ACTIVE);
+	if (ret)
+		ret = gpio_request_by_name(dev, "mosi-gpios", 0, &plat->mosi,
+					   GPIOD_IS_OUT | GPIOD_IS_OUT_ACTIVE);
 	if (ret)
 		plat->flags |= SPI_MASTER_NO_TX;
 
 	ret = gpio_request_by_name(dev, "gpio-miso", 0, &plat->miso,
 				   GPIOD_IS_IN);
+	if (ret)
+		ret = gpio_request_by_name(dev, "gpio-miso", 0, &plat->miso,
+					   GPIOD_IS_IN);
 	if (ret)
 		plat->flags |= SPI_MASTER_NO_RX;
 
Signature · 1 line
2.34.1
#1 lore raw

PATCH 2/2 doc: bindings: soft-spi: Remove the usage of deprecated properties

From: Fabio Estevam <[email protected]>

According to Documentation/devicetree/bindings/spi/spi-gpio.yaml from Linux, the recommended spio-gpio properties are:

sck-gpios, miso-gpios and mosi-gpios.

gpio-sck, gpio-mosi and gpio-miso are considered deprecated.

Update the bindings to suggest the recommeded properties.

---
 doc/device-tree-bindings/spi/soft-spi.txt | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)
doc/device-tree-bindings/spi/soft-spi.txt +6 -6
index dfb50664732f..bdf7e86befb9 100644
@@ -9,10 +9,10 @@ The soft SPI node requires the following properties:
 Mandatory properties:
 compatible: "spi-gpio"
 cs-gpios: GPIOs to use for SPI chip select (output)
-gpio-sck: GPIO to use for SPI clock (output)
+sck-gpios: GPIO to use for SPI clock (output)
 And at least one of:
-gpio-mosi: GPIO to use for SPI MOSI line (output)
-gpio-miso: GPIO to use for SPI MISO line (input)
+mosi-gpios: GPIO to use for SPI MOSI line (output)
+miso-gpios: GPIO to use for SPI MISO line (input)
 
 Optional propertie:
 spi-delay-us: Number of microseconds of delay between each CS transition
@@ -27,9 +27,9 @@ Example:
 	soft-spi {
 		compatible = "spi-gpio";
 		cs-gpios = <&gpio 235 0>;	/* Y43 */
-		gpio-sck = <&gpio 225 0>;	/* Y31 */
-		gpio-mosi = <&gpio 227 0>;	/* Y33 */
-		gpio-miso = <&gpio 224 0>;	/* Y30 */
+		sck-gpios = <&gpio 225 0>;	/* Y31 */
+		mosi-gpios = <&gpio 227 0>;	/* Y33 */
+		miso-gpios = <&gpio 224 0>;	/* Y30 */
 		spi-delay-us = <1>;
 		#address-cells = <1>;
 		#size-cells = <0>;
Signature · 1 line
2.34.1
Reviewed-by on v1 2/2
#2 lore raw

Re: [PATCH 2/2] doc: bindings: soft-spi: Remove the usage of deprecated properties

Quoted 6 lines · Fabio Estevam

From: Fabio Estevam <[email protected]>

According to Documentation/devicetree/bindings/spi/spi-gpio.yaml from Linux, the recommended spio-gpio properties are:

Quoted 8 lines

sck-gpios, miso-gpios and mosi-gpios.

gpio-sck, gpio-mosi and gpio-miso are considered deprecated.

Update the bindings to suggest the recommeded properties.

---

Applied to u-boot-spi/master

Reviewed-by on v1 1/2
#3 lore raw
In reply to Fabio Estevam
Quoted 8 lines · Fabio Estevam

From: Fabio Estevam <[email protected]>

According to Documentation/devicetree/bindings/spi/spi-gpio.yaml from Linux, the recommended spio-gpio properties are:

sck-gpios, miso-gpios and mosi-gpios.

Quoted 8 lines

gpio-sck, gpio-mosi and gpio-miso are considered deprecated.

Currently, U-Boot only supports the deprecated properties.

Allow the soft_spi driver to support both the new and old properties.

---

Applied to u-boot-spi/master