uboot-sign: add variables to set load address and entrypoint
PATCH 1/1 uboot-sign: add variables to set load address and entrypoint
According to the design of uboot-sign.bbclass and kernel-fitimage.bbclass, both of them use an UBOOT_LOADADDRESS variable to set the load address of kernel and u-boot image and use an UBOOT_ENTRYPOINT to set the entry address of kernel and u-boot image.
However, users may set the different load address of u-boot and kernel image. Therefore, adds UBOOT_FIT_UBOOT_LOADADDRESS and UBOOT_FIT_UBOOT_ENTRYPOINT to set the
load address and entry point of u-boot image, respectively.
The value of UBOOT_FIT_UBOOT_ENTRYPOINT is UBOOT_LOADADDRESS by default. The value of UBOOT_FIT_UBOOT_ENTRYPOINT is UBOOT_ENTRYPOINT by default.
Signed-off-by Jamin Lin <[email protected]>
--- meta/classes-recipe/uboot-sign.bbclass | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-)
meta/classes-recipe/uboot-sign.bbclass +5 -2
@@ -88,6 +88,9 @@ UBOOT_FIT_ADDRESS_CELLS ?= "1" # This is only necessary for determining the signing configuration KERNEL_PN = "${PREFERRED_PROVIDER_virtual/kernel}" +UBOOT_FIT_UBOOT_LOADADDRESS ?= "${UBOOT_LOADADDRESS}" +UBOOT_FIT_UBOOT_ENTRYPOINT ?= "${UBOOT_ENTRYPOINT}" + python() { # We need u-boot-tools-native if we're creating a U-Boot fitImage sign = d.getVar('UBOOT_SIGN_ENABLE') == '1'
@@ -248,8 +251,8 @@ uboot_fitimage_assemble() { os = "u-boot"; arch = "${UBOOT_ARCH}"; compression = "none"; - load = <${UBOOT_LOADADDRESS}>; - entry = <${UBOOT_ENTRYPOINT}>; + load = <${UBOOT_FIT_UBOOT_LOADADDRESS}>; + entry = <${UBOOT_FIT_UBOOT_ENTRYPOINT}>; EOF if [ "${SPL_SIGN_ENABLE}" = "1" ] ; then
Signature · 1 line
2.25.1