Bluetooth: btrtl: Add the support for RTL8922A

PATCH RESEND Superseded [email protected] 2 participants 2 messages Jul 11, 2024 Bluetooth drivers

lore

Share & tools

lore

[email protected]

author

2024-07-11 05:16 UTC #0 lore raw

PATCH RESEND v2 1/1 Bluetooth: btrtl: Add the support for RTL8922A

From: Max Chou <[email protected]>

Add the support for RTL8922A BT controller on USB interface. The necessary firmware will be submitted to linux-firmware project.

The device info from /sys/kernel/debug/usb/devices as below.

T:  Bus=01 Lev=02 Prnt=02 Port=02 Cnt=01 Dev#=  3 Spd=12   MxCh= 0
D:  Ver= 1.00 Cls=e0(wlcon) Sub=01 Prot=01 MxPS=64 #Cfgs=  1
P:  Vendor=0bda ProdID=8922 Rev= 0.00
S:  Manufacturer=Realtek
S:  Product=Bluetooth Radio
S:  SerialNumber=00E04C885A01
C:* #Ifs= 2 Cfg#= 1 Atr=e0 MxPwr=500mA
I:* If#= 0 Alt= 0 #EPs= 3 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=81(I) Atr=03(Int.) MxPS=  16 Ivl=1ms
E:  Ad=02(O) Atr=02(Bulk) MxPS=  64 Ivl=0ms
E:  Ad=82(I) Atr=02(Bulk) MxPS=  64 Ivl=0ms
I:* If#= 1 Alt= 0 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=   0 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=   0 Ivl=1ms
I:  If#= 1 Alt= 1 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=   9 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=   9 Ivl=1ms
I:  If#= 1 Alt= 2 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  17 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  17 Ivl=1ms
I:  If#= 1 Alt= 3 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  25 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  25 Ivl=1ms
I:  If#= 1 Alt= 4 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  33 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  33 Ivl=1ms
I:  If#= 1 Alt= 5 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  49 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  49 Ivl=1ms
I:  If#= 1 Alt= 6 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E:  Ad=03(O) Atr=01(Isoc) MxPS=  63 Ivl=1ms
E:  Ad=83(I) Atr=01(Isoc) MxPS=  63 Ivl=1ms

Signed-off-by Max Chou <[email protected]>

---
change in v2:
- update device info of commit log

---
 drivers/bluetooth/btrtl.c | 16 ++++++++++++++++
 drivers/bluetooth/btusb.c | 11 +++++++++++
 2 files changed, 27 insertions(+)

drivers/bluetooth/btrtl.c +16 -0

index f2f37143c454..555c2964ec1b 100644
@@ -30,6 +30,7 @@
 #define RTL_ROM_LMP_8822B	0x8822
 #define RTL_ROM_LMP_8852A	0x8852
 #define RTL_ROM_LMP_8851B	0x8851
+#define RTL_ROM_LMP_8922A	0x8922
 #define RTL_CONFIG_MAGIC	0x8723ab55
 
 #define RTL_VSC_OP_COREDUMP	0xfcff

@@ -69,6 +70,7 @@ enum btrtl_chip_id {
 	CHIP_ID_8852B = 20,
 	CHIP_ID_8852C = 25,
 	CHIP_ID_8851B = 36,
+	CHIP_ID_8922A = 44,
 	CHIP_ID_8852BT = 47,
 };

@@ -309,6 +311,15 @@ static const struct id_table ic_id_table[] = {
 	  .cfg_name = "rtl_bt/rtl8851bu_config",
 	  .hw_info  = "rtl8851bu" },
 
+	/* 8922A */
+	{ IC_INFO(RTL_ROM_LMP_8922A, 0xa, 0xc, HCI_USB),
+	  .config_needed = false,
+	  .has_rom_version = true,
+	  .has_msft_ext = true,
+	  .fw_name  = "rtl_bt/rtl8922au_fw",
+	  .cfg_name = "rtl_bt/rtl8922au_config",
+	  .hw_info  = "rtl8922au" },
+
 	/* 8852BT/8852BE-VT */
 	{ IC_INFO(RTL_ROM_LMP_8852A, 0x87, 0xc, HCI_USB),
 	  .config_needed = false,

@@ -655,6 +666,7 @@ static int rtlbt_parse_firmware(struct hci_dev *hdev,
 		{ RTL_ROM_LMP_8852A, 20 },	/* 8852B */
 		{ RTL_ROM_LMP_8852A, 25 },	/* 8852C */
 		{ RTL_ROM_LMP_8851B, 36 },	/* 8851B */
+		{ RTL_ROM_LMP_8922A, 44 },	/* 8922A */
 		{ RTL_ROM_LMP_8852A, 47 },	/* 8852BT */
 	};

@@ -1255,6 +1267,7 @@ int btrtl_download_firmware(struct hci_dev *hdev,
 	case RTL_ROM_LMP_8852A:
 	case RTL_ROM_LMP_8703B:
 	case RTL_ROM_LMP_8851B:
+	case RTL_ROM_LMP_8922A:
 		err = btrtl_setup_rtl8723b(hdev, btrtl_dev);
 		break;
 	default:

@@ -1286,6 +1299,7 @@ void btrtl_set_quirks(struct hci_dev *hdev, struct btrtl_device_info *btrtl_dev)
 	case CHIP_ID_8852B:
 	case CHIP_ID_8852C:
 	case CHIP_ID_8851B:
+	case CHIP_ID_8922A:
 	case CHIP_ID_8852BT:
 		set_bit(HCI_QUIRK_VALID_LE_STATES, &hdev->quirks);
 		set_bit(HCI_QUIRK_WIDEBAND_SPEECH_SUPPORTED, &hdev->quirks);

@@ -1529,3 +1543,5 @@ MODULE_FIRMWARE("rtl_bt/rtl8852btu_config.bin");
 MODULE_FIRMWARE("rtl_bt/rtl8852cu_fw.bin");
 MODULE_FIRMWARE("rtl_bt/rtl8852cu_fw_v2.bin");
 MODULE_FIRMWARE("rtl_bt/rtl8852cu_config.bin");
+MODULE_FIRMWARE("rtl_bt/rtl8922au_fw.bin");
+MODULE_FIRMWARE("rtl_bt/rtl8922au_config.bin");

drivers/bluetooth/btusb.c +11 -0

index acdba5d77694..ce08b5992d0e 100644
@@ -564,6 +564,17 @@ static const struct usb_device_id quirks_table[] = {
 	/* Realtek 8852BT/8852BE-VT Bluetooth devices */
 	{ USB_DEVICE(0x0bda, 0x8520), .driver_info = BTUSB_REALTEK |
 						     BTUSB_WIDEBAND_SPEECH },
+
+	/* Realtek 8922AE Bluetooth devices */
+	{ USB_DEVICE(0x0bda, 0x8922), .driver_info = BTUSB_REALTEK |
+						     BTUSB_WIDEBAND_SPEECH },
+	{ USB_DEVICE(0x13d3, 0x3617), .driver_info = BTUSB_REALTEK |
+						     BTUSB_WIDEBAND_SPEECH },
+	{ USB_DEVICE(0x13d3, 0x3616), .driver_info = BTUSB_REALTEK |
+						     BTUSB_WIDEBAND_SPEECH },
+	{ USB_DEVICE(0x0489, 0xe130), .driver_info = BTUSB_REALTEK |
+						     BTUSB_WIDEBAND_SPEECH },
+
 	/* Realtek Bluetooth devices */
 	{ USB_VENDOR_AND_INTERFACE_INFO(0x0bda, 0xe0, 0x01, 0x01),
 	  .driver_info = BTUSB_REALTEK },

Signature · 1 line

2.34.1

[email protected]

2024-07-11 05:59 UTC #1 lore raw

This is automated email and please do not reply to this email!

Dear submitter,

Thank you for submitting the patches to the linux bluetooth mailing list. This is a CI test results with your patch series:
PW Link:https://patchwork.kernel.org/project/bluetooth/list/?series=870325

---Test result---

Test Summary:

CheckPatch                    PASS      0.89 seconds
GitLint                       PASS      0.33 seconds
SubjectPrefix                 PASS      0.13 seconds
BuildKernel                   FAIL      23.55 seconds
CheckAllWarning               FAIL      25.73 seconds
CheckSparse                   FAIL      29.81 seconds
CheckSmatch                   FAIL      78.81 seconds
BuildKernel32                 FAIL      22.81 seconds
TestRunnerSetup               PASS      522.66 seconds
TestRunner_l2cap-tester       PASS      21.72 seconds
TestRunner_iso-tester         PASS      30.55 seconds
TestRunner_bnep-tester        PASS      4.82 seconds
TestRunner_mgmt-tester        PASS      110.32 seconds
TestRunner_rfcomm-tester      PASS      7.36 seconds
TestRunner_sco-tester         PASS      51.37 seconds
TestRunner_ioctl-tester       PASS      7.81 seconds
TestRunner_mesh-tester        PASS      9.88 seconds
TestRunner_smp-tester         PASS      6.96 seconds
TestRunner_userchan-tester    PASS      4.95 seconds
IncrementalBuild              FAIL      25.59 seconds

Details
##############################
Test: BuildKernel - FAIL
Desc: Build Kernel for Bluetooth
Output: