arm64: dts: qcom: monaco: Add EL2 overlay for monaco-arduino-monza
PATCH 1/1 arm64: dts: qcom: monaco: Add EL2 overlay for monaco-arduino-monza
Build an EL2 combined DTB for the Arduino VENTUNO Q (monaco-arduino-monza) from the base DTB and monaco-el2.dtbo, as monaco-evk-el2.dtb already does for the Monaco EVK.
The board boots under Gunyah by default. This DTB lets it run Linux at EL2 with KVM when the boot firmware is set up for that.
---
Build tested with CHECK_DTBS=y on top of qcom for-next. Not boot tested at EL2, the board ships boot firmware set up for Gunyah.
arch/arm64/boot/dts/qcom/Makefile | 4 ++++ 1 file changed, 4 insertions(+)
arch/arm64/boot/dts/qcom/Makefile +4 -0
@@ -68,6 +68,10 @@ dtb-$(CONFIG_ARCH_QCOM) += mahua-lenovo-thinkpad-t14s-gen7-lcd.dtb dtb-$(CONFIG_ARCH_QCOM) += milos-fairphone-fp6.dtb dtb-$(CONFIG_ARCH_QCOM) += milos-nothing-asteroids.dtb dtb-$(CONFIG_ARCH_QCOM) += monaco-arduino-monza.dtb + +monaco-arduino-monza-el2-dtbs := monaco-arduino-monza.dtb monaco-el2.dtbo + +dtb-$(CONFIG_ARCH_QCOM) += monaco-arduino-monza-el2.dtb dtb-$(CONFIG_ARCH_QCOM) += monaco-ac-evk.dtb dtb-$(CONFIG_ARCH_QCOM) += monaco-evk.dtb
Signature · 1 line
2.43.0
Quoted 8 lines · Pablo del Arco
Build an EL2 combined DTB for the Arduino VENTUNO Q (monaco-arduino-monza) from the base DTB and monaco-el2.dtbo, as monaco-evk-el2.dtb already does for the Monaco EVK.
The board boots under Gunyah by default. This DTB lets it run Linux at EL2 with KVM when the boot firmware is set up for that.
Signed-off-by Pablo del Arco <[email protected]>
Signature · 1 line
-Mukesh Ojha
Quoted 9 lines · Pablo del Arco
Build an EL2 combined DTB for the Arduino VENTUNO Q (monaco-arduino-monza) from the base DTB and monaco-el2.dtbo, as monaco-evk-el2.dtb already does for the Monaco EVK.
The board boots under Gunyah by default. This DTB lets it run Linux at EL2 with KVM when the boot firmware is set up for that.
Signed-off-by Pablo del Arco <[email protected]>---
Konrad
Quoted 8 lines · Pablo del Arco
Build an EL2 combined DTB for the Arduino VENTUNO Q (monaco-arduino-monza) from the base DTB and monaco-el2.dtbo, as monaco-evk-el2.dtb already does for the Monaco EVK.
The board boots under Gunyah by default. This DTB lets it run Linux at EL2 with KVM when the boot firmware is set up for that.
[...]
Applied, thanks!
[1/1] arm64: dts: qcom: monaco: Add EL2 overlay for monaco-arduino-monza
commit: 288c04d58f3cb8178540661d10ef95798170f545
Best regards,
Signature · 1 line
Bjorn Andersson <[email protected]>