Skip to contentSkip to conversation

NAND_ECC_NONE in u-boot question

U-Boot joe zhou 2 participants 2 messages Dec 4, 2009

lore
Share & tools
lore

joe zhou

author
#0 lore raw

Hi,

I am using 9G20 and set eccmode NAND_ECC_NONE in u-boot, but when I try to write some data from memory into flash with u-boot interface, it failed. (sam-ba can not read this page back from nand flash, it says a bad block). but I use NAND_ECC_SOFT, it is successful.
why? anyone can give some help?
Thanks in advance.

Signature · 2 lines
View this message in context: http://old.nabble.com/NAND_ECC_NONE-in-u-boot-question-tp26642489p26642489.html
Sent from the Uboot - Users mailing list archive at Nabble.com.
#1 lore raw
Quoted 7 lines · joe zhou

Hi,

I am using 9G20 and set eccmode NAND_ECC_NONE in u-boot, but when I try to write some data from memory into flash with u-boot interface, it failed. (sam-ba can not read this page back from nand flash, it says a bad block). but I use NAND_ECC_SOFT, it is successful.
why? anyone can give some help?

Telling U-Boot to ignore ECC (why do you want to do this?) does not also tell Linux to do so.

-Scott