ACPI: processor: Rearrange and clean up acpi_processor_errata_piix4()
Rafael J. Wysocki
maintainerPATCH 1/1 ACPI: processor: Rearrange and clean up acpi_processor_errata_piix4()
From: Rafael J. Wysocki <[email protected]>
In acpi_processor_errata_piix4() it is not necessary to use three struct pci_dev pointers. One is sufficient, so use it everywhere and drop the other two.
Additionally, define the auxiliary local variables value1 and value2 in the code block in which they are used.
No intentional functional impact.
Signed-off-by Rafael J. Wysocki <[email protected]>
--- drivers/acpi/acpi_processor.c | 29 +++++++++++++---------------- 1 file changed, 13 insertions(+), 16 deletions(-)
drivers/acpi/acpi_processor.c +13 -16
@@ -48,11 +48,6 @@ acpi_handle acpi_get_processor_handle(instatic int acpi_processor_errata_piix4 (struct pci_dev *dev) { -u8 value1 =0 ; -u8 value2 =0 ; -struct pci_dev *ide_dev =NULL , *isa_dev =NULL ; - -if (!dev)return -EINVAL ;
@@ -108,16 +103,16 @@ static int acpi_processor_errata_piix4(s* each IDE controller's DMA status to make sure we catch all * DMA activity. */ - ide_dev =pci_get_subsys (PCI_VENDOR_ID_INTEL , + dev =pci_get_subsys (PCI_VENDOR_ID_INTEL ,PCI_DEVICE_ID_INTEL_82371AB ,PCI_ANY_ID ,PCI_ANY_ID ,NULL ); -if (ide_dev) { - errata.piix4.bmisx =pci_resource_start (ide_dev,4 ); +if (dev) { + errata.piix4.bmisx =pci_resource_start (dev,4 );if (errata.piix4.bmisx) -dev_dbg (&ide_dev->dev, +dev_dbg (&dev->dev,"Bus master activity detection (BM-IDE) erratum enabled\n" ); -pci_dev_put (ide_dev); +pci_dev_put (dev); }/*
@@ -129,18 +124,20 @@ static int acpi_processor_errata_piix4(s* disable C3 support if this is enabled, as some legacy * devices won't operate well if fast DMA is disabled. */ - isa_dev =pci_get_subsys (PCI_VENDOR_ID_INTEL , + dev =pci_get_subsys (PCI_VENDOR_ID_INTEL ,PCI_DEVICE_ID_INTEL_82371AB_0 ,PCI_ANY_ID ,PCI_ANY_ID ,NULL ); -if (isa_dev) { -pci_read_config_byte (isa_dev,0x76 , &value1); -pci_read_config_byte (isa_dev,0x77 , &value2); +if (dev) { +u8 value1 =0 , value2 =0 ; + +pci_read_config_byte (dev,0x76 , &value1); +pci_read_config_byte (dev,0x77 , &value2);if ((value1 &0x80 ) || (value2 &0x80 )) { errata.piix4.fdma =1 ; -dev_dbg (&isa_dev->dev, +dev_dbg (&dev->dev,"Type-F DMA livelock erratum (C3 disabled)\n" ); } -pci_dev_put (isa_dev); +pci_dev_put (dev); }break ;