Skip to contentSkip to conversation

Booting on J200

parisc-linux Carl Johnson 1 participant 2 messages Dec 2, 1999 – Dec 3, 1999 1 message not in the archive

lore
Share & tools
lore
#0 lore raw

I have built my own kernels and modified them some, but have also used the prebuilt kernels, I have had no success figuring out what hangs the kernel but anyhow, I will tell of my testing of the 1999-10-19 and 1999-11-13. And Hopefully I will recieve some help, _TIA_

--
1999-10-19: Hangs at transfering control to kernel

--
1999-11-13: Hnags after:

Transfering control to kernel. (At entry point 0x00010000) kernel(0x00148C80, 0x00504010, 0x00148C80, 0x00016640) Clear BSS 0x0011B048 --> 0x0013D384
Boot Loader: PA/Linux, maybe PALO
real_mode setup exiting

--
1999-11-17 CVS snapshot with some of my own modif. to try to solve the hanging at real_mode.

__Will not build__

Signature · 1 line
Carl Johnson
#2 lore raw
In reply to a message not in the archive

Thanks Helge:

I never said I looked at the obvious first! Poor planning/thinking on my part. I did however about 2 secs before reading your post did recompile a FRESH ("VIRGIN") source and did manipulate the command line and get it to give me a Pengiun powered PA with a shell!

Thanks Anyhow!

Quoted 31 lines · Helge Deller

Am Wed, 01 Dec 1999 schrieb Carl Johnson:

Quoted 9 lines

I have built my own kernels and modified them some, but have also used the prebuilt kernels, I have had no success figuring out what hangs the kernel but anyhow, I will tell of my testing of the 1999-10-19 and 1999-11-13. And Hopefully I will recieve some help, _TIA_

--
1999-10-19: Hangs at transfering control to kernel

Quoted 9 lines

--
1999-11-13: Hnags after:

Transfering control to kernel. (At entry point 0x00010000) kernel(0x00148C80, 0x00504010, 0x00148C80, 0x00016640) Clear BSS 0x0011B048 --> 0x0013D384
Boot Loader: PA/Linux, maybe PALO
real_mode setup exiting

Hello Carl,

Are you shure, that the outputs doesn´t go to the first COM-Port as default (in which case you would never see something more on the screen)...

Check /arch/parisc/boot/boot_code/ipl_c.c and search for " console=ttyS0 " ... You would have to modify this (console=tty0) ** OR ** start the machine with "boot pri isl" and modify the command-line.

Helge Deller.

Signature · 1 line
Carl Johnson