trap handler for unaligned memory read/write
I was trying to run some PCI ether drivers and always got bus error, at least when I use ipconfig bootp code.
However, the problem seems to be generic.
Ethernet device writes a whole packet in the memory. Driver and network stack code often directly dereference a pointer in to the packet. However, the ether header is 14 byte long. If you align packet from the beginning, then IP header will be off-aligned.
Any suggestions?
If this is a valid problem, I think the long term solution should be in network code, which should not assume they can dereference on an unaligned address.
For short-term solutions, we can have trap handler that supports the unaligned read/write. Does anybody know if there is such a trap handler for MIPS?
Thanks.
Jun
As usual, I am replying to my own question. Maybe I was asking to soon ... :-)
I found some drivers offer an copy-only-tiny-buffer which will copy small packets (for what purpose?). Apparently after the copying the misalignment disappears. So MIPS, you just set a high copy_break_size so that a copying always happens.
In fact this is what is done for other non-x86 architectures in tulip drivers.
Jun
Quoted 24 lines · Jun Sun
I was trying to run some PCI ether drivers and always got bus error, at least when I use ipconfig bootp code.
However, the problem seems to be generic.
Ethernet device writes a whole packet in the memory. Driver and network stack code often directly dereference a pointer in to the packet. However, the ether header is 14 byte long. If you align packet from the beginning, then IP header will be off-aligned.
Any suggestions?
If this is a valid problem, I think the long term solution should be in network code, which should not assume they can dereference on an unaligned address.
For short-term solutions, we can have trap handler that supports the unaligned read/write. Does anybody know if there is such a trap handler for MIPS?
Thanks.
Jun
Quoted 11 lines · Jun Sun
I was trying to run some PCI ether drivers and always got bus error, at least when I use ipconfig bootp code.
However, the problem seems to be generic.
Ethernet device writes a whole packet in the memory. Driver and network stack code often directly dereference a pointer in to the packet. However, the ether header is 14 byte long. If you align packet from the beginning, then IP header will be off-aligned.
Any suggestions?
The strategy is to get the alignment right for the IP header, that is to make the received packet start on a address with bit 1 set.
Quoted 3 lines
If this is a valid problem, I think the long term solution should be in network code, which should not assume they can dereference on an unaligned address.
It tries to avoid unaligned accesses - if necessary even at the price of wasting some memory.
Quoted 3 lines
For short-term solutions, we can have trap handler that supports the unaligned read/write. Does anybody know if there is such a trap handler for MIPS?
It's right there in your kernel ...
You _really_ _really_ want to avoid relying on the unaligned trap handler. Performancewise that's equivalent to a swapping on a floppy disk on the Mars over NFS via avian carriers ...
However unaligned accesses will result in an address error exception not bus error therefore I suspect you've got another problem.
Ralf
Quoted 6 lines · Ralf Baechle
Quoted 3 lines
For short-term solutions, we can have trap handler that supports the unaligned read/write. Does anybody know if there is such a trap handler for MIPS?
It's right there in your kernel ...
Cool! I found it.
Quoted 7 lines
You _really_ _really_ want to avoid relying on the unaligned trap handler. Performancewise that's equivalent to a swapping on a floppy disk on the Mars over NFS via avian carriers ...
However unaligned accesses will result in an address error exception not bus error therefore I suspect you've got another problem.
I got the error when I use gdb to debug kernel. I suppose the gdb stub intercepted the error and report it as BUS error. We should make gdb-stub a little smarter ...
Jun