Problem with gigabit NIC acenic: 3c985b-sx
Dear all:
I've install a 3c985b-sx NIC on my linux 2.4.13 box. But when loading the 'acenic' module, it shows the message:
eth1: 3Com 3C985 Gigabit Ethernet at 0xdf020000, irq 10
Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:60:08:f7:04:1e PCI bus width: 32 bits, speed: 33MHz, latency: 64 clks
eth1: Firmware NOT running!
(PS. My eth0 is an intel eepro100)
It seems the driver detect the card but can't work. Is this a bug of my NIC firmware or a problem of the driver? Or what necessary steps I've missed?
Thanks in advance.
PS. Please CC your replis to me, thank you in advance.:)
--
Regards,
huangant <Chun-Ying Huang>
Quoted 10 lines · Chun-Ying Huang
Dear all:
I've install a 3c985b-sx NIC on my linux 2.4.13 box. But when loading the 'acenic' module, it shows the message:
eth1: 3Com 3C985 Gigabit Ethernet at
0xdf020000, irq 10
Tigon II (Rev. 6), Firmware: 12.4.11, MAC: 00:60:08:f7:04:1e PCI bus width: 32 bits, speed: 33MHz, latency: 64 clks
eth1: Firmware NOT running!
should be fixed in 2.4.14.
Signature · 3 lines
Jeff Garzik | Only so many songs can be sung Building 1024 | with two lips, two lungs, and one tongue. MandrakeSoft | - nomeansno