Skip to contentSkip to conversation

Write-combining

DISCUSSION SA products 1 participant 1 message Feb 12, 2002

lore
Share & tools
lore
#0 lore raw

Dear list,

Sorry this maybe off topic-- I am writing a device driver for a kind of framebuffer device.
This is virtually complete and working, all I wish to add is write-combining but I can find
very little information on how to do this. Looking at other device drivers MTRR crops
up a few times but I is still not clear to me what I have to do.

So far-
I grab the memory region for the framebuffer (1/4Mb) something like so;
......

memio=ioremap(pci_resource_start(dev,MEMIO)&PCI_BASE_ADDRESS_MEM_MASK,MEMIO_SIZE);

......
then try to mtrr it
.....

    err=mtrr_add(memio,MEMIO_SIZE,MTRR_TYPE_WRCOMB,1);

......
which fails because memio is not aligned correctly

my code generates the following messages
slm: init: mtrr option enabled- trying region cc960000
mtrr: base(0xcc960000) is not aligned on a size(0x40000) boundary
slm: init: mtrr: unable to set write combining for slm memory :(

Before I go any further I would like to ask is this a sensible approach or have I missed
something somewhere?

If this is not the most sensible way please point me towards a sensible solution-

If this is the correct way of doing things is there

Quoted 1 line

an easy way to discover the mtrr alignment requirements prior to

mtrr_add?

Quoted 2 lines

Can I align memio properly (how?) or
do I start by defining a larger mtrr region below memio and then

masking off the
unwanted regions either side of my memory region with
mtrr(...MTRR_TYPE_WRBACK..)?

Quoted 1 line

What happens on none x86 type processors?

any other advice?

Thanks SA