LInksys WMP11 (BCM4301 chip)
According to http://www.linuxworld.com/story/33804.htm, (Andrew Miklas), the BCM4301 is supported however I don't see any such critter in my source.
I find numerous mentions on the web about the v2.7 model of this bugger having switched to the BCM chip instead of the Prism chip.
Is there really any [kernel 2.6] support for this thing somewhere or do I have to email LinkSys a nastygram? :)
David
Quoted 2 lines · David Ford
According to http://www.linuxworld.com/story/33804.htm, (Andrew Miklas), the BCM4301 is supported however I don't see any such critter in my source.
This is a _terribly_ misleading article. There are only a few little bits of truth in the article you have referenced, and even that has been spun to exagerate the truth.
Broadcom has never released the source for the referenced chips to the general public. Those are closed source, binary-only, mipsel drivers for kernel 2.4.5 that are embedded within the device firmware.
-Erik
--
Erik B. Andersen http://codepoet-consulting.com/
--This message was written using 73% post-consumer electrons--