Skip to contentSkip to conversation

2.6.9-rc3 software suspend (pmdisk) stopped working

DISCUSSION Mitch 2 participants 2 messages Oct 2, 2004

lore
Share & tools
lore

Mitch

author
#0 lore raw

I don't understand. The highmem issue was when resuming, not when suspending ? My laptop doesn't suspend with -rc3. Please elaborate ? What config do i change ? Remember i don't have ACPI, so unless pmdisk supports APM BIOS poweroff, then -rc3 is useless to me.

Thanks
M
-------- Original Message --------
Subject: Re: 2.6.9-rc3 software suspend (pmdisk) stopped working
Date: Fri, 1 Oct 2004 15:40:05 +0200
From: Pavel Machek <[email protected]>
To: Mitch DSouza <[email protected]>
CC: [email protected]
References: <[email protected]>

Hi!

Quoted 2 lines

I thought i was going barmy. I've reverted back to -rc2 which pmdisk works flawlessly on my laptop.

Actually problem turned out to be in highmem. Unless you are using highmem, -rc3 should work. You'll need to change config if switching from pmdisk to swsusp...

Pavel

#1 lore raw

Hi!

Quoted 4 lines

I don't understand. The highmem issue was when resuming, not when suspending ? My laptop doesn't suspend with -rc3. Please elaborate ? What config do i change ? Remember i don't have ACPI, so unless pmdisk supports APM BIOS poweroff, then -rc3 is useless to me.

There's no pmdisk in -rc3.

swsusp in -rc3 should support apm.

Check your .config to see if it is enabled, and make sure you have resume= on command line. If it still fails, mail me dmesg of failed attempt.

Pavel

Signature · 2 lines
People were complaining that M$ turns users into beta-testers...
...jr ghea gurz vagb qrirybcref, naq gurl frrz gb yvxr vg gung jnl!