Skip to contentSkip to conversation

[Fwd: Delivery Status Notification (Failure)]

Fwd: Delivery Status Notification (Failure) Nebojsa Trpkovic 1 participant 1 message May 18, 2005

lore
Share & tools
lore
#0 lore raw

Unfortunately...

This is an automatically generated Delivery Status Notification.

Unable to deliver message to the following recipients, due to being unable to connect successfully to the destination mail server.

[email protected]

Frist Name : Nebojsa
Last Name : Trpkovic
Mail Date : 2005/5/17
Mail Address : [email protected]
Select Country : Germany
Telephone No :
FAX No :
Main Board Model : VNF3-250
VGA Type : Xelo Ti4200 8x
Product Serial Number : 0412035507
Distributor / Retailer : http://www.dualc.co.yu/
Problem Description : So, I have this issue and as I can see there are more people out there that have the same issue.<br>
On my board C'n'Q works fine if there is one RAM module. If there is two modules (no matter dimm 1 & 2 or 1 & 3 are populated) C'n'Q locks machine and I have to do hard reset.<br>
<br>
Memory modules are 2 x Kingmax Color RAM 466MHz CAS 3.0 256MB single sidded modules, running at 400MHz with timmings "BY SPD". In that situation, command rate is 2T but it does not help.<br>
It happens both in Windows and in Linux (Gentoo Linux with 2.6.11 kernel).<br>
<br>
C'n'Q works just as it should work if I put just one memory module, both in Windows and in Linux.<br>
<br>
All that is not so big problem to me because there's no way to dinamicly slow down fans on the board, so any dinamic changing of frequency looses its' significance.<br>
I wrote this to you because AMD represent on cpufreq list told me so.<br> <br>
Regards,<br>
Nebojsa Trpkovic<br>
<br>
P.S. I'm from Serbia & Montenegro and there's no way to select my country.<br>
<br>
<br>
<br>
<br>
If this problem also occurs on Windows, please report<br>
it to your motherboard manufacturer immediately. They'll<br> get it fixed.<br>
<br>
-Mark Langsdorf<br>
AMD, Inc.<br>
<br>
<br>

Quoted 35 lines
Quoted 13 lines

-----Original Message-----<br>
From: [email protected] <br> [mailto:[email protected]] On Behalf Of <br> Nebojsa Trpkovic<br>
Sent: Sunday, May 15, 2005 6:50 PM<br>
To: [email protected]<br>
Subject: Re: cpu-freq causing kernel lock-up after upgrading <br> to 1GB ram.<br>
<br>
<br>
Same problem here - VNF3-250 - if there's one RAM module <br> C'n'Q works fine, and if I put two modules it freezes every <br> time I try to change frequency, no matter linux or windows. <br>

Quoted 8 lines

So, it's not cpufreq related problem - it just buggy VNF3-250 <br> C'n'Q inplementation.<br>
<br>
<br>
<br>
<br>
chris stones wrote:<br>
<br>

<br>

Quoted 1 line
Quoted 1 line
Quoted 1 line

This is my first attempt at a bug report, so forgive me for <br>

<br>

Quoted 1 line

making a <br>

<br>

Quoted 9 lines
Quoted 9 lines
Quoted 9 lines

mess, I will try my best.<br>
<br>
-------------------------<br>
hardware:<br>
-------------------------<br>
mobo: Chaintech VNF3-250<br>
chipset: nForce-3<br>
CPU: amd64 Athlon 3400+<br>
Ram: 2 * Kingston 512Meg DDR400 PC3200 2T timeing 3-3-8-3. <br>

Quoted 10 lines

<br>

Quoted 1 line

(total 1GB) <br>

<br>

Quoted 7 lines
Quoted 7 lines
Quoted 7 lines

Swap : 1.3 Gb.<br>
<br>
--------------------------<br>
software:<br>
--------------------------<br>
Distro: Gentoo 2005.0 (comiped as 64bit with multilib)<br>
GCC: gcc version 3.4.3 20041125 (Gentoo Linux 3.4.3-r1,

ssp-3.4.3-0,<br>

Quoted 2 lines
Quoted 2 lines
Quoted 2 lines
Quoted 2 lines

pie-8.7.7)<br>
kernel versions: gentoo 2.6.11-r7; vanilla-2.6.10;

vanilla-2.6.11.9<br>

Quoted 7 lines
Quoted 7 lines
Quoted 7 lines
Quoted 7 lines

<br>
--------------------------<br>
description:<br>
--------------------------<br>
I have been using the modules freq_table, cpufreq_ondemand, <br> powernow_k8 to regulate my cpu clock for over 6 months with the <br> hardware configureation shown above, minus one 512meg ram

module.<br>

Quoted 5 lines
Quoted 2 lines
Quoted 2 lines
Quoted 2 lines

<br>
Recently, i shutdown the box, and added the second memory <br>

<br>

Quoted 1 line

module. At <br>

<br>

Quoted 13 lines
Quoted 1 line
Quoted 1 line
Quoted 1 line

the time, the cpu_fre drivers were compiled into the <br>

<br>

Quoted 1 line

kernel, shortly <br>

<br>

Quoted 1 line
Quoted 1 line
Quoted 1 line

after booting, the system would freese when cpu_freq <br>

<br>

Quoted 1 line

lowered my cpu to <br>

<br>

Quoted 5 lines
Quoted 5 lines
Quoted 5 lines

its idle state of 1Ghz.<br>
<br>
These conditions must all be met to cause the lock-up.<br>
1) Both Ram moodules are used (1GB ram)<br>
2) the modules freq_table, cpufreq_ondemand, powernow_k8 are

loaded.<br>

Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line

3) The lockup occurs when the cpu is slowing down from a period of

<br>

Quoted 3 lines
Quoted 3 lines
Quoted 3 lines
Quoted 3 lines

heavy load.<br>
<br>
2 hours running memtest86 shows that my memory is not the

problem.<br>

Quoted 6 lines
Quoted 2 lines
Quoted 2 lines
Quoted 2 lines

<br>
one one occasion, the kernel gave a memory dump before the <br>

<br>

Quoted 1 line

freeze. i <br>

<br>

Quoted 1 line
Quoted 1 line
Quoted 1 line

regret i didnt take note of its rull contents, but a function trace

<br>

Quoted 21 lines
Quoted 7 lines
Quoted 7 lines
Quoted 7 lines

line mentioned a cpu_freq function call.<br>
<br>
If i remove one of the 512meg memory modules, the cpu_freq <br> performsperfectly, as it has for the past 6 months.<br> <br>
Thankyou for taking the time to read my post.<br>
Is there anything i can do (other than go without ram or <br>

<br>

Quoted 1 line

cpu_freq) to <br>

<br>

Quoted 11 lines
Quoted 11 lines
Quoted 11 lines

solve this ? is there any more information you require from me ?<br> <br>
I have googled, but found no other similar bug reports.<br> <br>
From [email protected].<br>
<br>
_______________________________________________<br> Cpufreq mailing list<br>
[email protected] <br>
http://lists.linux.org.uk/mailman/listinfo/cpufreq<br>
<br>

Quoted 9 lines

<br>

Quoted 8 lines

<br>
<br> _______________________________________________<br> Cpufreq mailing list<br> [email protected] <br>
http://lists.linux.org.uk/mailman/listinfo/cpu> freq<br> <br>
<br>

BIOS Date : 2004/10/19
CD Version :
Operating System : both Windows and Linux 2.6.11 CPU Type : AMD Athlon64 3000+ (Newcastle core) Memory Modules : 2 x 256MB Kingmax Color RAM 466MHz CAS 3.0 Other Devices :

_______________________________________________
Cpufreq mailing list
[email protected]
http://lists.linux.org.uk/mailman/listinfo/cpufreq