Skip to contentSkip to conversation

how to initramfs

U-Boot-Users Hurricane555 2 participants 3 messages May 23, 2006

lore
Share & tools
lore
#0 lore raw

I?m a little confused! What?s the difference between initramfs and initrd?

How can I create a runable initramfs for my linux Kernel?

Where can I found an example for a rootfs (2.6.10)?

Is a initramfs or initrd essential for a linux prompt?

Because at the moment my serial output shows only this:

U-BOOT# bootm 50040000
## Booting image at 50040000 ...

   Image Name:   NS9750 Kernel
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1074991 Bytes =  1 MB

Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
OK

Starting kernel ...

--
View this message in context: http://www.nabble.com/how+to+initramfs-t1667406.html#a4518657
Sent from the Uboot - Users forum at Nabble.com.

#1 lore raw
Quoted 2 lines · In message <[email protected]> you wrote:

I?m a little confused! What?s the difference between initramfs and initrd?

And what has this to do with U-Boot?

Quoted 1 line

How can I create a runable initramfs for my linux Kernel?

And what has this to do with U-Boot?

Quoted 1 line

Where can I found an example for a rootfs (2.6.10)?

And what has this to do with U-Boot?

Quoted 1 line

Is a initramfs or initrd essential for a linux prompt?

And what has this to do with U-Boot?

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Dear Lord: I just want *one* one-armed manager so  I  never  have  to
hear "On the other hand", again.